User manual POLK AUDIO TC610

[. . . ] 2 Get more information and exclusive accessories, visit www. FIGURE 4 TC615i model: Holding the edges of the oblong tweeter carefully between the thumbs and forefingers of both hands, rock the tweeter slightly to aim it. When used as rear/surrounds, aim tweeter toward the nearest reflecting surface (an adjacent wall or ceiling) for a more diffuse sound field. FIGURE 5 TC610i model: Grasping the round tweeter with the tips of the fingers of one hand, pivot the tweeter in the direction you desire. [. . . ] Keyhole saw, utility knife or material--appropriate incising implement for cutting drywall or other wall material. Screwdriver, preferably powered, with Phillips head bit. â· Power drill with appropriate bit (optional, for starting wall cut). Make sure the material into which you plan to mount the speakers (plaster, drywall, paneling, stone, etc. ) can support the weight of the speakers (see specification page for the weight of your model). â· Make sure the locations you select do not conceal studs, electrical wiring or plumbing. Prior to installation, hold the speaker in your chosen location to make sure it safely clears obstacles such as studs, corners, beams, lighting fixtures and door/window frames. Your cutout must be at least 1" (25mm) from adjoining walls or ceiling, internal studs or plumbing. â· Using the template, trace the installation location with a pencil. You can do this by holding the template in your preferred location and tracing around it (rectangle) or within the template pop-out area (round). Use a level to make certain the template is straight and plumb. This is the exact cutout size [figures 10a & 10b]. â· Carefully cut the hole with the appropriate cutting tool for your wall or ceiling material. start the hole by drilling a hole on the inside of the tracing (with the drill bit touching the line). Use this hole to insert the saw or knife and begin cutting [figure 11]. Once you have cut the hole, fish your previously positioned wiring out of the hole and connect the speaker. Follow the hookup directions included with your receiver. Strip 1/2 inch (12 mm) of insulation from each of the two conductors of the wire to expose the bare metal and twist each of the conductors into a single unfrayed strand (so you have two unfrayed strands). Note that one of the terminals on the rear of each speaker is red (+) and the other is black (-). Make certain that you connect the wire from the red terminal (+) of your amplifier or receiver to the red terminal (+) on your speaker and the wire from the black terminal (-) of your amplifier or receiver to the black terminal (-) on your speaker. Most wire has some indicator (such as color-coding, ribbing or writing) on one of the two conductors to help you maintain consistency [figure 12]. â· To install the speaker, first carefully remove the grille using a straightened paperclip or other pointed metal tool. [. . . ] , warrants, to the original retail purchaser only, that any AMPLIFIER OR OTHER ELECTRONIC COMPONENT that may be included in this Polk Audio Loudspeaker Product will be free from defects in material and workmanship for a period of three (3) years from the date of original retail purchase from a Polk Audio Authorized Dealer. To allow Polk Audio to offer the best possible warranty service, please register your new product online at: www. Com/registration or call Polk customer service 800-377-7655 in the USA and Canada (outside the USA: 410-358-3600) within ten (10) days of the date of original purchase. Be sure to keep your original purchase receipt. [. . . ]