User manual POLTI AROMA 1500 DIGIT

[. . . ] Do not use the appliance if the power cable or other important parts are damaged. · Do not use electric extension leads that are not authorized by the manufacturer, as they may cause damage or fire. · If it is necessary to replace the power supply cable, please refer to the nearest Polti authorised service centre, since the use of a special tool is necessary. · Never touch the appliance with wet hands or feet with the cable plugged into the mains. [. . . ] Insert the separator disk (K) on the supply tube (L), tongue it correctly (fig. Pay attention to the arrow, which MUST point in the same direction as the coffee delivery (fig. Rest the coffee maker on the base (F) correctly (fig. 7). You can now proceed to the manual or programmed coffee maker start- up, following the instructions below. The indicator light (V) turns on to indicate that the coffee maker is operating. Coffee delivery will begin after a few minutes. When all the coffee has been delivered, the start/stop indicator light (V) turns off and the writing "END" appears on the display together with 5 beeps. To remove the writing "END" just press any button. CORRECT PRODUCT USE This appliance is intended for household use only according to the descriptions and instructions contained in this user manual. Please read these instructions carefully and keep them, they could be useful in the future. WA R N I N G S · This appliance has been built in keeping with the current regulations on the recycling. · It is recommended not to throw in the domestic rubbish the protective packaging materials used in transportation but to deliver them to the appropriate collecting centre. · We recommend only the use of original spare parts. disclaims all responsibility in case of accident due to the use of this appliance which is not in keeping with the present directions for use. PLEASE NOTE All our products are rigorously tested before leaving the factory. I N S TA L L AT I O N Place the appliance on a work surface away from water. O P E R AT I O N Connect the power cable (G) to an electrical socket of the correct voltage. The horizontal lines on the display (N) begin to flash. Now the time can be set or coffee can be made. SETTING THE TIME The time can be set pressing the button (O) until the exact start-up time appears on the display. Holding down the button (O) the time will increase more rapidly. 5 seconds after the last button press(O), the displayed time is memorised. NB: The start-up time cannot be modified if "Programmed start-up" function is active ("Programmed start-up" indicator light(T) on). [. . . ] Remove the scale from the lower vessel Clean the disk filter as described in the "General maintenance advice" paragraph. Replace the gasket. The coffee takes a long time The coffee used is not the right type to be released The disk filter is blocked. Scale presence into the boiler Coffee leaks from the edges The disk filter is blocked of the boiler. The gasket is burned or torn The coffee maker has not been started Start the coffee maker correctly. [. . . ]