User manual POLTI AS 510

[. . . ] · The wiring system to which the appliance is connected must always comply with the laws in force. · In order to avoid prejudicing the safety of the appliance, use only original spare parts and accessories approved by the manufacturer. Fig. 4 ENGLISH AS510 · Do not use the appliance if the power cable or other important parts are damaged. · If the supply cable needs replacing, please advise to consult the nearest Authorised Assistance Centre, because a special tool is required. [. . . ] To increase or decrease length, press the catch (A1) and extend or reduce length as desired. Using the universal brush (B) Connect the brush to the telescopic tube. If you move the selector on the brush (B1) and press with a foot, you can change the suctioning surface without bending down. The position with bristles extended is recommended for all non-carpeted floors. The position without bristles is recommended for carpets. Using the Small Brush (E) Thanks to its soft bristles, the small brush is suitable for dusting delicate surfaces like frames, books and so on. . . The small brush can be used with or without bristle fitting (E1). To separate the fitting from the brush just pull it outwards (fig. 4) Using the Lance for edge cleaning (F) This lance is suitable for thorough cleaning of the most difficult places, like skirting-boards, sofa gaps, armchairs, upholstered furniture, car seats. Automatic Cable Winder Before putting the vacuum cleaner away, rewind the power cable by pressing the button (8), being careful to accompany it during winding. CORRECT USE OF THE PRODUCT This appliance is intended for vacuuming solids in accordance with the descriptions and instructions provided in this manual. Please read these instructions carefully and keep them safely where you or other users can refer to them: they may be useful in the future. FUNCTIONING · Unroll the supply cable (11) till reaching the yellow sign on the cable itself, by pulling it as shown in fig 1. DO NOT under any circumstances unroll beyond the red sign. · Plug into a suitable power outlet. · Push the switch (7), the appliance will start operating. The ON/OFF switch (7) can also be operated by touching it with your foot, so you do not have to bend. · It is possible to regulate suction power through the slide control (9). Moving it to the right, the suction power increases, while moving to the left, the suction power will decrease. · We recommend minimum power for curtains, medium low power for sofas, armchairs and cushions, medium high for carpets and high for floors and hard surfaces (ceramics, marble, etc. ). · Thanks to the manual suction regulator (C2), the suctioning power can be changed according to the cleaning task, and it allows to intervene promptly in case of accidental suctioning (e. g. We recommend an open regulator on curtains, carpets, sofas and so on. . . [. . . ] Fitting the mains plug important The wires in the mains lead are coloured in accordance with the following code: · Blue: Neutral · Brown: Live The wire which is coloured BLUE must be connected to the Terminal which is marked with the letter "N" or coloured BLACK. The wire which is coloured BROWN must be connected to the Terminal which is marked with the letter "L" or coloured RED. It is important that the outer sheath is clamped correctly into the 3-pin plug. If in doubt consult your local Service Dealer or qualified electrician before the machine is used. [. . . ]