User manual POLTI ESPRESSO SUPER AUTOMATIC

[. . . ] â· Do not touch the hot parts, the steam pipe and the water after use. â· Do not operate the coffee grinder without container and its cover. Before starting the operations, make sure that all the components are correctly placed, as shown in the picture in the KEY. The capacity is of about 2, 6 L which allows a good operating range. [. . . ] In this way you can reach the coffee length regulator handle (22). With this handle (22) you can set as you like the amount of water to be used for the preparation of your coffee: by turning the handle clockwise, more water will be used and so the coffee will be longer. The machine is equipped with a selection button (1) for automatic dispensing of longer coffee. The indicator light will light up making a BEEP. Wait a few minutes for the indicator light to be on. Push the washing cycle button (6) by using a cup to collect the water coming out from the dispensers (21); this operation is made for cleaning the machine and taking it to an optimum condition for the dispensing of the first coffee. Put the cup on the drip-tray (13) underneath the coffee dispensers (21) (fig. Push the button (2): in this way the machine makes all the steps in sequence until the dispensing of the desired dose in the cup. The dispensing of the drink can be stopped by pushing any button (1-2-3-4-5-6) Operate with the indicator light on. The dispensing of two coffees happens with two consecutive preparation cycles divided into two cups. Put two cups on the drip-tray (13), each one underneath a coffee dispenser (21). Push the button (3), the machine will make two consecutive operation cycles. Then wait until the complete dispensing of the desired dose in the cups. Put the cup or an empty container under the dispenser (14). Push the button (6), the dispensing of hot water will start and will last until it gets to 200 cc. Put the container with the liquid under the dispenser (14) and push the steam button (5). After a few minutes, the steam will come out untill you push the button again. The steam lance is set for frothing milk, allowing easier frothing during the steam heating of the milk. Should the machine be used for the dispensing of one coffee immediately after the steam dispensing, it is advisable to do a washing cycle by pushing the button (6) to restablish the correct water temperature. Wa s h i n g b u t t o n The machine is equipped with a button (6) which operates the washing of the filters and of the infusion chamber. [. . . ] Put the container back in its correct position. This indicator light indicates the connection of the machine to the mains and the end of the control test. When you open the cover, the indicator light will go out because the presence of a safety device cuts the power supply from the machine. The indicator light will light up together with a sound signal to advise that the machine is out of water. [. . . ]