User manual POLTI FERRO CARESSE FE602/603

[. . . ] Filling the tank · The tank must be filled only when the power cord is unplugged from the mains. · Put the steam control cursor in the low position (fig. 2) · Unhook the water tank by the hook (G) (fig. · Remove the tank (A) from the iron and fill it under the tap keeping it at 45° (fig. 4) · Hold the iron keeping the tip downwards. [. . . ] During extra steam output the steam control cursor can be held in any position. To obtain a better result, it is advisable to place the cursor in the "closed" position. · For optimal performance with Shot of Steam, it is advisable to wait 4 seconds between each press. Water spray · By pressing the appropriate button (H), a water spray is obtained over the fabrics to be ironed (fig. In order to make use of this feature it is necessary to fill the tank with water. · The water spray helps you to dampen dry items and to iron starched items. It is also useful for low temperature dry ironing. · The water spray can be used both during steam ironing as well as during dry ironing. Dry Ironing · If water is present inside the iron, turn the cursor (C) to the "0" position (fig. 2) · Turn the thermostat (E) to the appropriate position for the fabric to be ironed. · Insert the plug in an earthed socket. A thermostat pilot light (D) will switch on. · Wait until the pilot light (D) switches off and commence ironing. Ironing without tank · To make steam ironing easier in difficult to reach places like shirt sleeves, pockets, trouser legs, it is possible to use the iron without the tank, using the steam output for about 5 minutes (fig. 10). CLEANING AND MAINTENANCE AFTER IRONING After ironing, follow these procedures: · Turn the steam control cursor to pos. "0" · Unplug the appliance from the mains · To empty the remaining water in the tank, keep the point downwards and unhook the tank as described in the "Filling the tank" paragraph. · Unplug the iron and wipe the sole plate with a wet cotton cloth in order to clean any marks from the sole plate. But do not rub too vigorously to avoid scratching the plate. · To clean the iron outside, simply use a damp cloth. Avoid using abrasive cloths or detergents which may cause damage to the plastic surface. [. . . ] · Only use cable extensions which are in perfect condition and equipped with an earth. Never use the iron in the following circumstances: · The iron or the power cord are damaged · The iron has been dropped or has been knocked severely · Water is leaking from the iron. WA R N I N G S · In case of malfunctioning or failure never attempt to disassemble the iron, but contact your nearest authorised Polti Service Centre. · In case of damage to the power cord. It should be replaced by an authorised Polti Service Centre. [. . . ]