User manual POLTI LECOLOGICO ESPECIAL PARQUET

[. . . ] 11 A C C E S S O R I O PA R Q U E T ( N ) J 5-A G C I C L O D I A S C I U G AT U R A Fig. 16 BIOECOLOGICO H I B B1 E I n t e r v e n t o d e l s e n s o r e u mFig. i18 id tà Fig. 19 BIOECOLOGICO BIOECOLOGICO 2 ENGLISH 19 L E C O L O G I C O E S P E C I A L PA R Q U E T CORRECT USE OF THE PRODUCT This appliance is intended for use as an aspirator for solids according to the descriptions and instructions in this manual. It is recommended to read these instructions carefully and to store them for future use. [. . . ] (Figure 6b). · · Switch off the appliance at the mains switch (11) and disconnect the power supply cable from the mains. Disconnect the tube from the junction by turning it anticlockwise. Push the opening button (8) on the upper cover (7). Lift the cover (7) by turning it upwards as indicated in fig. Lift the container handle (6) by taking it to the height of the tube hole as in fig. Take out the container (5) by pulling it out of the appliance (fig. 11) Pull the water filter cage (20) upwards and then pull it out (fig. Unhook the elbow tube locking ring (25) by pulling it outwards (fig. Pull the elbow tube (26) from the filter body (24) until it slips off (fig. Divide all the components as described in the key and then rinse them under running water (if the sponge filter is damaged, replace it by contacting a Polti Authorized Service Centre) Before putting the sponge filters (22-23) back, wring them by using a cloth so as to dry them perfectly. Reassemble the water filter group (20) by repeating the operation in reverse. 3 ENGLISH HOW TO EMPTY AND CLEAN T H E WAT E R TA N K L E C O L O G I C O E S P E C I A L PA R Q U E T NOTE: before reassembling the water filter, make sure that all the parts have been properly dried. Put the filter group (20) back into the container (5) so as to insert the elbow tube (26) between the two projections of the container (fig. Gently push the water container handle (6) until the two slots on the handle fit with the two pins (4) on the appliance (fig. Before storing the appliance or before using it again, make a drying cycle as described in the "Drying cycle" paragraph. Empty the water container (5) and rinse it. Unhook the elbow tube locking ring (25) by pulling it towards the outside (fig. Pull the elbow tube (26) from the microspore sponge filter body (24) until it slips off (fig. Divide all the components as described in the key and then rinse them under running water (if the sponge filter is damaged, replace it contacting a Polti Authorized Service Centre). Before putting the sponge filters (22-23) back, wring them by using a cloth so as to dry them perfectly. NOTE: before reassembling the water filter, make sure that all parts have been properly dried. Put the filter group (20) back into the container (5) so as to insert the elbow tube (26) between the two projections of the container (fig. 16). · · · · · · · · D RY I N G C Y C L E · Warning: make the drying cycle with the empty tank. [. . . ] You must not use the appliance in environments where there is danger of explosion Do not suck up objects in flames or glowing, such as embers, ash and other materials while burning. Should there be a liquid or foam leak during aspiration, immediately switch off the appliance and contact the nearest Polti Authorised Service Centre. Polti declines liability for any damage or accident derived from any use of LECOLOGICO which is not in conformity with the instructions contained in this booklet. ELECTRICAL SAFETY No earth required. Ensure the mains voltage suits your appliance. [. . . ]