User manual POLTI MICHELANGELO INSTRUCTIIONS FOR USE

[. . . ] ® Michelangelo 3 4 5 6 7 8 9 2 1 10 11 12 21 17 16 18 19 15 14 22 Fig. A 13 20 25 12b b 12a 12c d AROMA MICHELANGELO - Edizione 1I06 26 Fig. C a 23 24 9 AROMA MICHELANGELO Dear Customer, Thank you for choosing this Polti product. With this coffee machine, you will enjoy full taste and aroma right from the first cup and make creamy cappuccino as well as tea and other hot drinks. [. . . ] The words PROGRAM FILTER will appear on the display. From this position you may continue programming or exit by pressing exit. Don't forget to programme water hardness when not using the filter. WATER HARDNESS The frequency of lime scale removal depends on the hardness of your local water supply. Set water hardness correctly as soon as you begin using the machine so that the system will be able to inform you when the lime scale procedure is necessary. First test the water using the litmus paper (26) supplied: Fill a small container with tap water. Dip the litmus paper into it and remove it immediately, then shake it gently. After about one minute you will be able to read the results by counting the red dots. Different levels are distributed as shown below: ­ ­ ­ ­ 1 red dot = 1 -7° dH / 1 - 12. 6°fH = LEVEL 1 2 red dots = 8 -14° dH / 12. 7 -25. 2°fH = LEVEL 2 3 red dots = 15-21° dH / 25. 3-37. 8°fH = LEVEL 3 4 red dots = > 21° dH / > 37. 8°fH = LEVEL 4 The factory setting corresponds to LEVEL 3. (It will appear only if the filter is programmed to NO). Press > again until the level of water hardness determined in the litmus paper test appears on the display. Confirm by pressing ok, and the words PROGRAM W. From this position you may continue programming or exit by pressing exit. TEMPERATURE You may change coffee temperature to suit your preferences, setting it to NORMAL, HIGH or MAXIMUM. The factory setting is "High". Press > again until the desired temperature level appears on the display. Confirm by pressing ok, and PROGRAM. TEMP. From this position you may continue programming or exit by pressing exit. TIME You must programme the current time before you can programme on time. Press the programming button P to go into Programming mode. Press ok, and TIME SETTING will appear on the display. HOURS > 00:00 will appear on the display. [. . . ] ­ The tray (9b) and/or coffee grounds container (9c) is absent or has not been installed correctly. ­ The contacts (9d) on the drip tray are dirty. SYSTEM TOO HOT PLEASE CLEAN SYSTEM CALCIF. . ­ Overheated system ­ The machine needs cleaning. [. . . ]