User manual POLTI RAFFAELLO INSTRUCTIIONS FOR USE

[. . . ] AROMA RAFFAELLO Dear Customer, Thank you for choosing a Polti product. With this coffee machine, you will enjoy full taste and aroma right from the first cup and make creamy cappuccino as well as tea and other hot drinks. AROMA RAFFAELLO is made with top quality components to ensure quality and perfect safety. Please read these instructions carefully before using AROMA RAFFAELLO. MACHINE CONTROLS AND COMPONENTS 1. [. . . ] This is important as you must use the lime scale removal programme if you are not using the filter. Turn off the machine using the on/off button (2) (Stand-by mode). Press the service button (7) for about 2 seconds to enter Programming mode. symbols will come on in sequencomes on and 5c. The symbols will start flashing. 6c. Press the selector (4) until only the is flashing, indicating that the filter has been excluded (Filter OFF). Confirm by pressing the service button (7) for about 2 seconds. Programming concludes and the system goes back to Stand-by mode. Don't forget to programme water hardness when not using the filter. WATER HARDNESS The frequency of lime scale removal depends on the hardness of your local water supply. Set water hardness correctly as soon as you begin using the machine so that the system will be able to inform you when the lime scale procedure is necessary. First test the water using the litmus paper (26) supplied: Fill a small container with tap water. Dip the litmus paper into it and remove it immediately, then shake it gently. After about one minute you will be able to read the results by counting the red dots. Different levels are distributed as shown below: ­ ­ ­ ­ 1 red dot = 1 -7° dH / 1 - 12. 6 °fH 2 red dots = 8 -14° dH / 12. 7 -25. 2 °fH 3 red dots = 15-21° dH / 25. 3-37. 8 °fH 4 red dots = > 21° dH / > 37. 8 °fH = = = = . ENGLISH When no red dots are visible, set the 1d. Turn the machine off using the on/off button (2) (Stand-by mode) 2d. Press the service button (7) for about 2 seconds to go to Programming mode. The symbols will come on in sequence (The water hardness symbol will not appear if the filter is set to "On"; refer to the "FILTER" section). Wait until the symbol comes on and confirm by pressing the selector (4). Wait until the filter symbol press the selector (4). symbols will start flashing. AROMA RAFFAELLO 6d. Press the selector (4) until the symbols corresponding to the desired level flash. Confirm by pressing the service button (7) for about 2 seconds. [. . . ] ­ Fill the container (18) with coffee beans. Flash in ascending order Flashes ­ The drip tray (9b) and/or coffee ­ Empty the drip tray and/or coffee grounds container (9c) is full. ­ The drip tray (9b) and the coffee ­ Install the drip tray (9a) and the coffee grounds container (9c) have grounds container (9c). been removed or incorrectly ­ Clean the contacts. ­ Drip tray contacts (9d) are dirty. [. . . ]