User manual POLTI STIRA & ASPIRA LUX

[. . . ] Stira&Aspira has a suction function, to avoid creases on the clothing, so common with traditional ironing boards. The suction function also facilitates the ironing of creases in trouserlegs or pleats. In the special "LUX" model, the surface has a heating function too, drying clothes and making ironing even smoother, quicker and less tiring. ENGLISH The ironing surface is covered by a thick flannel and a cotton poplin cloth, these can be washed in the washing machine. [. . . ] · Activate the automatic closing hook lever (B) only if the board is resting horizontally on the ground; pay attention during board opening and closing procedures and always guide the board up from the floor. · If in the future you need replace the ironing board fabric cover or the lining, always be sure that the replacement is permeable to humidity. Humidity resistant fabrics can be damaged by heat or moisture. · WARNING: The heated surface (ON LUX MODEL ONLY)reaches high temperatures both on and under the cloth, so take care not to touch it. The plug (H) for your iron can be accessed by opening the cover (G). Press the general/board heating switch (D), wait for a few minutes to reach working temperature (model Lux only). Now operate the suction by pressing the switch (E). Notice: To avoid condensation forming inside the board, please ALWAYS use the suction function during steam ironing. CLOSING 1c. Switch off the general switch (D) (only mod. NOTICE (only mod. Lux): before putting away the board, leave the board heating (D) switched on for a few minutes so as to dry out any possible condensation formed during the ironing. Disconnect the plug from the power socket. Roll the feeding cable (I) around the fitted housing (J). Pull upwards the opening lever (B), always holding the board surface (A) during closing. For storage the equipment can stand up by itself in a vertical position. TRASPORT I M P O R TA N T · If repairs or replacement parts are required, use only original Polti replacement parts. · If it is necessary to replace the power supply cable, please refer to the nearest Polti authorised service centre, since the use of special tool is necessary. · In the case of breakdown or malfunction do not attempt to repair the appliance yourself but refer to your nearest authorised service centre. TO OPEN THE BOARD 1a. Pull upwards the opening lever (B) and raise the board to the required height, holding the surface (A). Activate lever (B) to fix the board at the chosen height. [. . . ] This appliance may be fitted with a non rewirable plug, if it is necessary to change the fuse in a non rewirable plug the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement, available from the appliance manufacturer, is obtained. It is important that the colour of the replacement fuse cover corresponds with the colour marking on the base of the plug. [. . . ]