User manual POLTI STIRA E ASPIRA

[. . . ] M0S05484 - Edizione 2G10 Stira e Aspira - Cod. M0S04152 - Edizione 1G01 10 2 7 9 3 Fig. [. . . ] Push the on/off switch (4), which will light up. At this point you can activate the aspiration by pushing the suction switch (5). Push the suction switch (5) (Fig. 2) which will light up. It will allow you to hold the clothes on the board and to eliminate the residual humidity. Note: it is important to always use the aspirator while you use the steam iron in order to avoid the formation of water condensation inside the ironing board. CLOSING 1b. Close the Vaporella supporting-grill (3). Pull the opening handle (2) and support the board (1) as it descends to the floor. Lift the ironing board vertically with the point downwards. 4 Rewind the supply cable (8) to its storage (6) as shown in figure (5). The ironing board can now be stored. WA R N I N G · In case of damage or malfunction, do not try to disassemble the appliance but address to the authorised Polti After-Sales Service nearest to you. The supply cable must be replaced by the manufacturer or its After-Sales Service, so as to prevent any risk. · ATTENTION: if you iron sitting down, do not place your legs under the ironing board, the steam can cause burns. ENGLISH Stira e Aspira FOR YOUR OWN SAFETY READ FOLLOWING INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO CONNECT THIS UNIT TO THE MAINS. M A I N S ( A C ) O P E R AT I O N This unit is designed to operate on 240V, 50 Hz current only. Connecting it to other power sources may damage the unit. WARNING - This appliance must be earthed. [. . . ] The wire which is coloured blue must be connected to the terminal which is marked with the letter "N" or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter "L" or coloured red. [. . . ]