User manual POLTI VAPORELLA ADVANCED SYSTEM

[. . . ] The suction keeps the fabric sticked to the board, preventing the formation of creases which rise up easily with other ironing boards. The airing function inflate delicate fabrics so that it is possible to iron over with steam power only. Vaporella Advanced System helps you to work safely. This product conforms with very strict regulations. [. . . ] This jug, is the ideal solution to the problem of limescale allowing you to change water straight from the tap into water that is demineralized and silicon-free. In this way you can prevent the incrustations and protect the components of your unit. Constant use of the jug extends the life to your appliance and you will always have at your disposal a clean jet of steam To use the jug correctly, please read carefully the instructions provided with this item. Connect the power supply cable (D) into an earthed power supply of the correct voltage. Press the main switch (B); the steam pressure indicator (K) and the "iron heating" indicator light (J1) will light up (fig. To operate the board, turn the main switch (C) on. In this way the board heater will start operation. Wait a few minutes to allow the heater to reach working temperature. It is now possible to activate blowing and suction features: Fig. 3 ENGLISH Vaporella Advanced System 9a. BLOWING: By pushing the function switch (P) on posi- Fig. 4 tion (I), the board will allow you to swell the clothes with a "hot blow", in order to be able to gently skim with the iron the most delicate clothes, ironing them with steam only. 10a. SUCTION: By pushing the function switch (P) on position (II), the board will hold the clothes to the surface and eliminate the residual humidity. Note: to avoid condensation inside the ironing board we recommend you always use the suction function while steam ironing. The sound emitted on switching on your appliance and periodically during use, is due to the water refilling system and is quite normal. During use you may hear some gurgling due to the backflow of hot water into the tank saving energy (water preheating in the tank). This is quite normal and you can carry on ironing. To reduce the gurgling we recommend to replenish before the water has been used up. At first steam request, or about 2 minutes after the last request, you will experince a delay in steam delivery because steam inside the heat exchanger is excessively rarefied. This is normal and no longer happens once the equipment has been used a number of times. Press the steam release switch (H) for some seconds till steam is released. INSTRUCTIONS FOR USE STEAM IRONING 1b. Set the iron temperature to the "COTTON - LINEN" steam position (fig. [. . . ] This indicates the machine maintaining the correct and constant pressure and is quite normal. · If no steam is released from the iron, check the following: the switch (K) is lit up; there is water in the tank. · If repairs or replacement parts are required. Vaporella Advanced System ENGLISH · The appliance is fitted with a safety thermostat, which should only be replaced by an authorised technician. · If it is necessary to replace the power supply cable, please refer to the nearest Polti authorised service centre, since the use of special tool is necessary. [. . . ]