User manual POLTI VAPORELLA PRO 4100 R

[. . . ] â· Before connecting Vaporella to the mains make sure that the current is the same as indicated for the machine and that the plug is an earthed plug. â· Do not introduce any detergent or chemical substance into the generator tank. If your tap water is very hard, please use our special decalcifier TP 2000 PROGRESSO CASA with a natural basis, which is sold in all Polti services. [. . . ] Connect the power supply cable (D) into an earthed power supply of the correct voltage (230V - 240V). Switch on the boiler and iron by pressing the switches (B) and (C) which will light up (fig. All types of fabric can be ironed at this temperature. Wait for the generator on/off switch (B) to go out (about 10 minutes). Push button (H) on the iron to release bursts of steam from the holes on the soleplate. NOTE: during initial operation of the iron, a few drops of water mixed with steam may come out of the soleplate until the temperature stabilises. It is advisable to direct the first jets of steam onto an old cloth until a uniform stable jet of steam is obtained. Steam will keep on coming out, even releasing the button. By turning the steam flow control knob (L) you can vary the amount of steam according to the type of textile to be ironed (more or less delicate). You can use this control to increase the steam flow by turning in anti-clockwise direction. All Polti machines are equipped with the unique Polti patented safety cap, which prevents opening of the generator tank as long as there is any pressure remaining inside the tank. This is an important and indispensable safety device, and it is necessary to follow certain procedures when re-filling the tank. Whenever when you have used up all the water in the tank, do as follow : 1a. Disconnect the power supply cable (D) from the mains. Wait 3 or 4 minutes to allow the generator tank to cool down. When cool proceed to carefully refill the tank as described in paragraph 3 of the section "PREPARATION FOR USE" in the instructions. If refilling the generator when not completely cooled, we recommend that you carefully pour only very small quantities of water at each pouring into the tank, so as to avoid spitting from the tank. Iron only on heat resistant surfaces and on surfaces that allow the steam to escape e. [. . . ] Never empty the Vaporella when the water in the generator is still hot. â· To clean the body of the appliance, simply use a moist cloth. Do not use solvents or detergents which may harm the body material. [. . . ]