User manual POLTI VAPORETTO 2000

[. . . ] The wire which is coloured blue must be connected to the terminal which is marked with the letter "N" or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter "L" or coloured red. Before using your VAPORETTO carefully read these usage instructions. â· Before connecting VAPORETTO to the mains make sure that the current is the same as that indicated for the machine and that the plug is an earthed plug. [. . . ] All POLTI machines are equipped with the unique Polti patented safety cap, which prevents opening of the generator tank as long as there is any pressure remaining inside the tank. This is an important and indispensable safety device, and it is necessary to follow certain procedures when re-filling the tank. According to model, `water out' is indicated by a warning light (J), or by an audible alarm signal from the machine, or on more basic models by the exhaustion of the steam output. Whenever you have used up all the water in the tank, follow the following procedures: 1c. switch off the machine at the generator on/off switch (B) 2c. Press the steam request lever (3) on the hand gun (2) or, if using the iron, the steam request button (R) on the iron (Q) so as to fully exhaust the steam supply from the tank. Disconnect the power supply cable (F) from the mains. Wait 3 to 4 minutes to allow the generator tank to cool down. When cool proceed to carefully refill the tank as described in paragraph 1 of the section "Preparation for Use" in the instructions. If refilling the generator when not completely cooled, we recommend that you carefully pour only very small quantities of water at each pouring into the tank, so as to avoid spitting from the tank and cover exposed skin whilst filling. For dry ironing set the temperature control dial according to the fabric to be ironed as indicated on the dial. Wait three to four minutes for the indicator (R) to go out indicating that the sole plate of the iron has reached the correct temperature. Releasing this button stops the steam flow. At first you may find that the steam contains some water globules and we recommend that the first jet of steam is therefore played onto an old cloth, and is not directed onto the garment to be ironed. For dry ironing do not press the steam request button (R). The iron can also be used in a vertical position e. Iron only on heat resistant surfaces and on surfaces that allow the steam to escape e. When cleaning electric ovens, refrigerators, or other electrical equipment, always disconnect the electrical item to be cleaned from the mains before cleaning. â· For cleaning leather, wood or delicate fabrics especially dralon, velvet and other pile surfaces, consult the manufacturers instructions. Clean only by using the hand gun at a safe distance together with a soft cloth and always do a test on a non visible part of the item first or on a sample. Allow the test area to dry completely before observing results and effects on surface or colour before proceeding to clean further areas, ensuring that exactly the same distance and technique are applied as for the test area. If in doubt, and on sensitive surfaces like fabrics, leather and wood it is always better to ask advice from your Steam Cleaner dealer. [. . . ] Your glass wilI remain cleaner longer thanks to the absence of layers of film normally left behind by chemical cleaning products on which new dust and grease can attach itself. Cleaning glass is done in two stages: - Spraying the steam onto the surface to be cleaned to loosen the dirt (not touching with blade). - Pulling the blade straight down the window surface from top to bottom without applying the steam, to take away the dirt. - To clean especially large glass surfaces, attach the Window Squeegee Tool to the extension tubes. [. . . ]