User manual POLTI VAPORETTO 2010/2010 KIT

[. . . ] ® VAPORETTO FOREVER 2010 - 2010 KIT B D A C E H I L F 2 7 G 10 11 8 3 5 6 R S Q 1 4 9 12 15 16 14 13 U T 5 Fig. 7 Ed. 1P05 VAPORETTO FOREVER 2010 - 2010 KIT Read these instructions carefully before using the appliance. GENERATOR A) Tank cap; B) ON/OFF BUTTON; C) Steam ready indicator light; D) Low water level indicator light E) Steam control knob; F) Power cable; G) Cable winder; H) Carry handle; I) Socket with anti-spray cover; L) Socket retainer opening; ACCESSORIES 1) Sheath; 2) Steam gun; 3) Steam control lever; 4) Safety button; 5) Plug block; 6) Pin for connecting plug block; 7) Extension tubes; 8) Large brush; 9) Lever connections; 10) Squeegee tool; 11) Accessory locking button; 12) Terry cloth cover; 13) Cotton cloth; 14) Funnel; 15) 120° tool; 16) Round brush for 120° tool; OPTIONAL ACCESSORIES (Included in model 2010 Kit) Q) Iron; R) Steam button; S) Temperature control knob; T) Iron rest; U) Iron heating indicator light This unit conforms with EC-directives 2004/108/CE (EMC) and 2006/95/CE (low voltage). reserves the right to change equipment or accessory specification without prior notice. [. . . ] I M P O R TA N T Before leaving our factory all our products are rigorously tested. For this reason, your VAPORETTO may contain some residual water in the boiler from the testing. P R E PA R AT I O N · Lift up the tank cap (A) (Fig. · Before turning on the product, fill the tank with water making sure that it does not overflow (Fig. 2) Never use distilled water or scented water. · Put the tank cap (A) back in position. · Plug the power cable (F) into an earthed socket. H O W TO U S E · Press the ON/OFF button (B). · Open the door on the socket block (I); insert the plug block (5), being careful to make sure that the connecting pin (6) is perfectly positioned in the retainer opening (L) on the socket (fig. · Wait until the steam ready indicator light (C) comes on. At this point your VAPORETTO is ready for use. · The steam gun (2) has a safety button (4) to prevent accidental dispensing of steam by children or people who don't know how to use the appliance. When the button (4) is set to "OFF" the lever commanding steam is locked (fig. 4). If you need to leave the sheath momentarily unsupervised while the appliance is turned on, set the safety switch to "OFF" (fig. 4). To start using steam, set the button (4) to "ON" and work the steam lever (3). The first time you use the appliance, a few drops of water may come out because the temperature has not stabilised perfectly inside the sheath. We recommend you direct the first jet of steam onto a cloth, until the jet of steam is uniform. NOTE: The steam ready indicator light (C) will go on and off which you are using your VAPORETTO. This indicates that the electrical resistance is working to keep pressure constant and should be considered normal. S T E A M R E G U L AT I O N F E AT U R E VAPORETTOs are equipped with a steam regulator control (E) (Fig. You can increase the steam flow by turning the control in a clockwise direction. Turning it in an anti-clockwise direction reduces the steam flow. Here are some suggestions for the choice of steam flow level: · Strong steam: for encrusted dirt, stains, sanitising, grease. [. . . ] LARGE BRUSH (8) To clean floors, place the brush on the cotton cloth (13), fix it in place with the lever hooks provided (9), and move the appliance back and forth without applying pressure. When one side of the cloth is dirty, turn it over. Use the brush without the cloth on particularly dirty areas or encrustations and to clean between tiles, using a sideways movement to get dirt out. Use the steam gun directly in hard-to-reach corners and on stains, wiping them with the cloth afterwards. [. . . ]