User manual POLTI VAPORETTO 2085

[. . . ] ® VAPORETTO 2085 A G B 5 3 2A 1 C 2 D E F 9 6 4 11 9 12 11 H 11 13 9 8 10 22 7 11 14 15 11 16 11 24 17 20 11 21 23 V U R S Q 18 11 19 T 5 6 4 Fig. 5 ON OFF VT 2085- M0S07125 - Ed. 1O03 2 VAPORETTO 2085 Read these instructions carefully before using the appliance. PRECAUTIONS KEEP THESE INSTRUCTIONS · Read these instructions for use carefully before using the appliance. · Any use which does not comply with these instructions will invalidate the warranty. · The wiring system to which the appliance is connected must always comply with the laws in force. [. . . ] Unscrew the patented safety cap (A) and fill the boiler with about 1. 3 litres of water using the special funnel (14) making sure that it does not overflow (fig. 1). However, as water by its nature contains limestone, which may cause a build-up of limescale in the boiler, in hard water areas we recommend the use of our naturalbase decalcifier KALSTOP FP 2003. Carefully screw on the safety cap to hand tight (Fig. Ensure the patented safety cap (A) is fully and correctly screwed on, otherwise you may experience steam escaping from around the cap. Connect the power supply cable (F) into an earthed power supply of the correct voltage. WARNING: Do NOT under any circumstances put or leave the filler funnel in the water filling aperture of the appliance when the appliance is connected to the mains electricity supply. The first burst of steam may contain some water droplets, due to imperfect thermic stabilisation inside the flexible hose. We would therefore advise that the first jet of steam is played onto an old cloth until a constant pressure of steam is obtained. Note: The generator on/off switch (B) may go on and off from time to time during use of VAPORETTO. This indicates the machine is maintaining the correct and constant pressure and is quite normal. If the flexible hose is too much twisted during use, the NO-VOLT device stops the steam flow. To resume the steam release, press the steam request button. CONNECTION OF THE ACCESSORIES All the accessories of VAPORETTO can be connected to the handle or to the extension tubes as follows (fig. Move the accessories locking button (11) on every accessory to the "OPEN" position. Attach the required tool to the hand gun or to the extention tube. 3b. Move the accessories locking button (11) back to the "CLOSED" position. Check that the connector button has engaged and the accessory is fully connected. PAT E N T E D S A F E T Y C A P / '' WAT E R O U T '' The appliance is equipped with a safety cap, which prevents opening of the boiler as long as there is any pressure remaining inside. This is an important and indispensable safety device, and it is necessary to follow certain procedures when re-filling the boiler. Whenever you have used up all the water in the boiler, proceed as follows: 1c. Switch off the machine at the generator on/off switch (B) 2c. Press the steam request button (3) on the steam gun (2) or, if using the iron, the steam request button (R) on the iron (Q) so as to fully exhaust the steam supply from the boiler. 3c. Switch OFF the accessory on/off switch (C). 4c. Disconnect the power supply cable (F) from the mains. [. . . ] Particularly dirty rugs may need several treatments. Obstinate stains may require the use of the steam gun prior to treatment. SMALL BRUSH (12) The small brush is used whenever the big brush is too big or not practical to be used. The small brush can be connected directly to the steam gun or to the extension tubes. [. . . ]