User manual POLTI VAPORETTO MOP

[. . . ] · Do not allow the power cord to be twisted, crushed, stretched, or come into contact with sharp or hot surfaces. · Do not use the appliance if the power cable or other important parts are damaged. · Do not use electric extension leads that are not authorized by the manufacturer, as they may cause damage or fire. · If it is necessary to replace the power supply cable, please refer to the nearest Polti authorised service centre, since the use of a special tool is necessary. [. . . ] Appropriate separate collection to permit recycling, treatment and environmentally compatible disposal helps prevent negative impact on the environment and human health and promotes recycling of the materials making up the product. For more information on available collection facilities, contact your local waste collection service or the shop where you bought this appliance. Attach the appropriate accessory for the cleaning task at hand, as shown in fig. When you connect up the brush (8), the Vaporetto Mop will stand up unaided. To release accessories press the accessory release button (K) and pull off the accessory. NOTE: Accessories (4), (5), (6) and the power cable are stored in the accessory holder \ support for storing the appliance (3). Adjust the grip height as required by turning the grip height adjustment ring while pulling on the grip. When you release the ring the grip will lock in position. Release the water tank (G) by pressing the two tank release buttons (E) while pulling on the tank (fig. Turn the water tank cap (G) anticlockwise to open it and fill the tank with ordinary tap water (max 600 cc) (fig. If your tap water is particularly hard (rich in magnesium and minerals which produce lime scale), we recommend you use demineralised water to ensure longer life for your appliance. Close the cap (F) and put the tank back in its housing, proceeding to perform the same operations as described above in reverse. Connect the power cable to the power cable socket (J) and then plug it into a grounded electrical outlet. Hook the power cable to the anchor hook (M) so that it will not get in the way while you are cleaning (fig. Put the ON/OFF button (B) in the ON position. The on/off indicator (H) will start to flash. The appliance will be ready to produce steam only 15 SECONDS after you turn it on. When you grasp the grip with the on/off sensor (A) as shown in fig. 5 · Do not put any detergent or chemical substance in the tank. · We recommend you use original Polti products only, as products of other brands may not be suitable for use in Polti products and could cause damage. · Never use distilled water or scented water. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Let the cloth dry before using it again. CLEANING THE WATER TANK (G) Clean the water tank as follows: · Remove the tank from the appliance as described in the section on "preparation". · Unscrew the cap on the bottom of the tank and remove it from the tank (fig. · Remove the silicone tube from the cap and the dipping point (fig. [. . . ]