User manual POLTI VAPORELLA FOREVER 1600 ECO

[. . . ] Our Technical Development team have added a range of sophisticated improvements to make cleaning tasks both safer and more effective: · The No Volt System - a unique Polti patent, designed so that there is no electricity to the on/off switch on the handle, making it absolutely safe even if the handle is accidentally brought into contact with liquids. The No Volt System offers the additional safety feature of only being able to operate when the user is present the steam switches itself off immediately the handgreep is released. · Splash Proof Design - splash proof design makes Vaporetto proof against the machine being splashed or sprayed. · Unique Polti Patented Safety Cap - prevents opening whilst any residual pressure remains in the system. [. . . ] Open the cover of the central connector block (D) and insert the central connector (4) pressing the connector button (5) and taking care that the locking tab (6) is correctly positioned in the lock-in aperture (E) on the block (Fig 3). Wait for the pressure warning light (K) (where available) to go out. (Note: on some models where there is no separate pressure indicator light, instead wait for the light inside the generator on/off switch (B) to go out). 3 Vaporetto 2400 NV ENGLISH 4a. The steam gun (2) is equipped with a safety switch (2A) Fig. 4 which prevents the accidental start of the steam jet by children or people who do not know how to operate the appliance. With the switch 2A in the "OFF" position, the lever controlling the steam jet is locked. Should the hose be left unattended for a moment whilst the appliON ance is connected to the mains, it is recommended to F OF put the safety switch in the "OFF" position. To start the steam jet, move the 2A switch backwards (ON) and activate the steam request lever (fig. 4). The first burst of steam may contain some water droplets, due to imperfect thermic stabilisation inside the flexible hose. We would therefore advise that the first jet of steam is played onto an old cloth until a constant pressure of steam is obtained. Wait for a few minutes to allow the generator tank to cool down. When cool proceed to carefully refill the tank as described in paragraph 1 of the section "Preparation for Use" in the instructions. If refilling the generator when not completely cooled, we recommend that you carefully pour only very small quantities of water at each pouring into the tank, so as to avoid spitting from the tank and cover exposed skin whilst filling. USE OF THE PROFESSIONAL STRENGTH PRESSING IRON (normally sold separately) 1d. Connect the connector block at the end of the iron hose (4) to the generator as shown in point 2a of the section "Instruction for Use". For all steam ironing, position the temperature indicator dial (S) to the position "COTONE - LINO". For dry ironing set the temperature control dial according to the fabric to be ironed as indicated on the dial. Wait for a few minutes for the indicator (R) to go out indicating that the sole plate of the iron has reached the correct temperature. Press the steam request button on the iron (R) to allow the steam to exit. Releasing this button stops the steam flow. At first you may find that the steam contains some water globules and we recommend that the first jet of steam is therefore played onto an old cloth, and is not directed onto the garment to be ironed. For dry ironing do not press the steam request button (R). [. . . ] HOW TO USE THE NON-DRIP BOTTLE (14) Unscrew the cap and fill the bottle with water, put the cap back on the neck of the bottle by inserting first the small tube into the body and then screwing tight. Put the spout of the bottle close to the filling duct and then insert it. When the level of water in the boiler reaches the tip of the spout, the water flow stops automatically. You can then move the bottle back to a vertical position. [. . . ]