User manual POLYCOM KIRK 7010 QUICK GUIDE

[. . . ] (You must assign a key to a number in Phone Book). 4 Scroll to the appropriate speed dial entry (0-9) and then press Add name. From Call List 1 Press left side of navigation key to enter Call list. 2 Scroll to desired name or number and press . [. . . ] To reduce the risk of electrical shock or burns, do not disassemble this product. Opening or removing covers may expose you to dangerous voltages, dangerous electrical current, or other risks. Incorrect reassemble can cause electrical shock when the appliance is subsequently used. If the product need repair, consult your dealer. Avoid using telephone during an electrical storm. There may be a risk of electrical shock from lightning. Do not use the telephone to report a gas leak in the vicinity of the leak. Do not place the base or charger near microwave ovens, radio equipment, or non-ground connected televisions. These appliances may cause electrical interference to the base or handset. The charger must be placed on a hard, flat surface and connected to a functional 120 volt AC power source depending on the country of use. This telephone will not operate in the event of a blackout. Please keep a backup phone for emergencies. Installation must be performed in accordance with all relevant national wiring rules. Plug acts as Disconnect Device - The socket outlet to which this apparatus is connected must be installed near the equipment and must always be readily accessible. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. Do not use the handset in conditions where there is a danger of electrically ignited explosions. Exposure to sunlight, heat and moisture Do not expose the wireless phone to direct sunlight for long periods. Keep the wireless phone away from excessive heat and moisture. Spare parts and accessories Use only approved spare parts and accessories. The operation of nonapproved parts cannot be guaranteed and may even cause damage. Power failure In the event of a power failure or flat battery, you cannot use the handset to make or receive calls. Periodically clean the charge contacts on both the charger and handset. [. . . ] This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. IC Note: Operation is subject to the following two conditions: (1) This device May not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The Term "IC": before the certification/ registration number only signifies that the Industry Canada technical specifications were met. Privacy of communications may not be ensured when using this telephone. [. . . ]