User manual POLYCOM PTB450 REV C

[. . . ] Link Wireless Telephone and Accessories Model PTB400/410 Model PTB450 Link Dual Charger Link Quick Charger Link Quad Charger User Guide Part Number: 72-0075-09 Issue C SpectraLink Corporation Link Wireless Telephones and Accessories User Guide Trademark Information Polycom® and the logo designs SpectraLink® LinkPlus Link NetLink SVP Are trademarks and registered trademarks of Polycom, Inc. in the United States of America and various countries. All other trademarks used herein are the property of their respective owners. Notice Polycom, Inc. has prepared this document for use by Polycom personnel and customers. [. . . ] Flashing yellow--the Link Quick Charger is testing and conditioning the Battery Pack. This test/condition mode is automatically started every 11th cycle of the charger. Testing the NiMH high-capacity Battery Pack takes approximately eight to ten hours. To manually start the test, press the MODE button. To stop the test, press the MODE button. However, it is highly recommended that the test be allowed to complete. Battery Pack bins If a handset is to be used during the recharging cycle, fully charged Battery Packs must always be available. Therefore, it is recommended that a bin is available to collect discharged Battery Packs and a second bin for charged Battery Packs. Users can quickly replace their discharged Battery Pack with a charged one. An assigned person can recharge the Battery Packs and move them to the charged bin as they are recharged. It is also recommended that the bins be non-metallic and clearly labeled to identify whether they are intended for charged or discharged Battery Packs. Part Number: 72-0075-09-C. doc Page 14 SpectraLink Corporation Link Wireless Telephones and Accessories User Guide Link Quad Charger (shown with two empty charging bays) Link Quad Charger Model BC4900 Overview The Link Quad Charger is designed to simultaneously charge four PTS360 NiMH (Nickel Metal Hydride) Battery Packs. The Link Quad Charger is only authorized for use in the U. S. The Link Quad Charger may be mounted on a horizontal or vertical surface. Power supply The power supply that is required for this unit is the SpectraLink part number GCX100A. Set up the Link Quad Charger by plugging the power supply into the Link Quad Charger and into an appropriate wall outlet. A solid red LED above an empty charger slot indicates that the slot is idle and ready for use. If the LEDs do not light, check the power supply and plug connection to the charger. If the charger appears to be plugged in correctly, make sure the wall outlet has power. Position the Battery Pack in a charging slot by aligning the top of the Battery Pack with the tracks on the charging slot then gently sliding the Battery Pack upward onto the charging slot. While the Battery Pack is in the charging slot, the LED above the slot will indicate the status of the charging process and/or the Battery Pack. LED status indicators Solid Green--the Battery Pack is charging. The Link Quad Charger takes 60-90 minutes to fully charge a Battery Pack. [. . . ] Cet appareil numérique de la classe A est conforme à la norme NMB-003 due Canada. International Certifications United States Canada 3 UL 60950 CAN/CSA-22. 2 No. 60950 United States Part 15 TUV Rheinland of North America is a Nationally Recognized Testing Laboratory (NRTL) in the United States and is accredited by the Standards Council of Canada to test and certify products to Canadian National Standards. Clients can demonstrate compliance for both U. S. and Canadian markets through a single mark (cTUVus) on their product(s) which denotes compliance to U. S. [. . . ]