User manual POULAN 210

[. . . ] WARNING: Always disconnect spark plug wire and place it where it cannot contact plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. WARNING: This snow thrower is for use on sidewalks, driveways and other ground level surfaces. Caution should be exercised while using on sloping surfaces. Do not use snow thrower on surfaces above ground level such as roofs of residences, garages, porches or other such structures or buildings. [. . . ] BEFORE STOPPING Run the engine for a few minutes to help dry off any moisture on the engine. IF RECOIL STARTER HAS FROZEN If the recoil starter has frozen and will not turn the engine, proceed as follows: 1. Grasp the recoil starter handle and slowly pull as much rope out of the starter as possible. Release the recoil starter handle and let it snap back against the starter. If the engine still fails to start, repeat the above steps or use the electric starter. SNOW THROWING TIPS · · · · · · · · · · · Always operate the snow thrower with the engine at full throttle. Full throttle offers the best performance. Go slower in deep, freezing or heavy wet snow. Use the drive speed control, NOT the throttle, to adjust speed. It is easier and more efficient to remove snow immediately after it falls. The best time to remove snow is the early morning. At this time the snow is usually dry and has not been exposed to the direct sun and warming temperatures. The belts on your snow thrower are of special construction and should be replaced by original equipment manufacturer (OEM) belts available from your nearest dealer. Using other than OEM belts can cause personal injury or damage to the snow thrower. SNOW THROWER Always observe the safety rules when performing any maintenance. TIRES · Maintain proper air pressure in both tires (14­17 P . S. I. · Keep tires free of gasoline and oil, which can harm rubber. NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot 14 and corrosion. MAINTENANCE AUGER GEAR CASE · The gear case was filled with lubricant to the proper level at the factory. The only time the lubricant needs attention is if service has been performed on the gear case. · If lubricant is required, use only Ronex ED #1 grease. TRACTION DRIVE SYSTEM DO NOT lubricate the drive components inside the snow thrower. The sprockets, hex shafts, drive disc and friction wheel require no lubrication. The bearings and bushings are lifetime lubricated and require no maintenance. [. . . ] Failure to do so could be hazardous, damage your snow thrower and void your warranty. 37 REPAIR PARTS BAG OF PARTS SNOW THROWER - MODEL PP11530ES (96192001903) 3 5 4 2 1 6 8 7 01. 14. 004-A KEY NO. 198563 169675 180684 73800600 19131316 198636 198638 73800400 DESCRIPTION POWER CORD RETAINER PIN WRENCH LOCKNUT 3/8-16 WASHER 3/8 SHEAR BOLT 1/4-20 X 1-3/4 SPACER LOCKNUT 1/4-20 1 KEY NO. 35062 DESCRIPTION SAFETY IGNITION KEY NOTE: All component dimensions given in U. S. [. . . ]