User manual POULAN 285

[. . . ] WARNING: Always Remove safety ignition key and disconnect spark plug wire and place it where it cannot contact plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. WARNING: This snow thrower is for use on sidewalks, driveways and other ground level surfaces. Caution should be exercised while using on sloping surfaces. Do not use snow thrower on surfaces above ground level such as roofs of residences, garages, porches or other such structures or buildings. [. . . ] The best time to remove snow is the early morning. At this time the snow is usually dry and has not been exposed to the direct sun and warming temperatures. Slightly overlap each successive path to ensure all snow will be removed. Adjust the skid plates to proper height for current snow conditions. See "TO ADJUST SKID PLATES" in this section of this manual. For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly. Keep engine clean and clear of snow during use. This will help air flow and extend engine life. After snow-throwing is completed, allow engine to run for a few minutes to melt snow and ice off the engine. Clean the entire snow thrower thoroughly after each use and wipe dry so it is ready for next use. WARNING: Do not operate snow thrower if weather conditions impair visibility. The sprockets, hex shafts, drive disc and friction wheel require no lubrication. The bearings and bushings are lifetime lubricated and require no maintenance. CAUTION: Any lubricating of the above components can cause contamination of the friction wheel and damage to the drive system of your snow thrower. Remove safety ignition key and disconnect spark plug wire from spark plug. Place wire where it cannot come in contact with plug. Remove drain plug and drain oil in a suitable container. Install drain plug and tighten securely. Wipe off any spilled oil from snow thrower and engine. Install left wheel (if removed for draining oil). Be sure to install klick pin into proper hole in wheel axle (See "TO REMOVE WHEELS" in the Service and Adjustments section of this manual). Be careful not to allow dirt to enter the engine. [. . . ] 285 (28500) BAG OF PARTS 3 5 4 KEY NO. 198563 169675 180684 73800600 19131316 198636 198638 73800400 DESCRIPTION POWER CORD RETAINER PIN WRENCH LOCKNUT 3/8-16 WASHER 3/8 SHEAR BOLT 1/4-20 X 1-3/4 SPACER LOCKNUT 1/4-20 2 1 6 8 7 01. 14. 004-A 1 KEY NO. 35062 DESCRIPTION SAFETY IGNITION KEY NOTE: All component dimensions given in U. S. 1 inch = 25. 4 mm IMPORTANT: Use only Original Equipment Manufacturer (O. E. M. ) replacement parts. [. . . ]