User manual POULAN C342B

[. . . ] Do r un INGmowe RNerate WA t op no les nta s co ine r is jec ssub erlyi prop t to ar we d de an tierio eck n. en ce cked cra en wh or da ma ge d. Us e on ly a de en mm reco d re pla nt ceme r. ine conta Do r un INGmowe RNerate WA t op no les r is ine nta s co prop erlyi ssub jec t to ar we tierio d de an n. [. . . ] From backside of drawbar place reinforcement plate so that weld screws go through holes in left side of drawbar. Place support tube over weld screws and assemble flat washer, lockwasher, and wing nut as shown Do not tighten at this time. Discard remaining shoulder bolts in hardware GROUP "A". SUPPORT TUBE REINFORCEMENT PLATE HEX BOLTS SHOULDER BOLTS LANCED TABS TOWARD BOTTOM FIG. 1A FLAT WASHERS LOCK WASHERS WING NUTS 02 35 3 If your tractor does not have four (4) shoulder bolts installed on the drawbar, follow the instructions below (See Fig. Using the four formed holes in the drawbar, install the four self tapping shoulder bolts as shown and tighten securely. Hang the mounting bracket, lanced tabs towards bottom, on the bolts. Assemble the support tube to drawbar as shown. From backside of drawbar place reinforcement plate so that weld screws go through holes in left side of drawbar. Place support tube over weld screws and assemble flat washer, lockwasher, and wing nut as shown Do not tighten at this time. Discard remaining hex bolts and locknuts in hardware GROUP "A". 7 LANCED TABS TOWARD BOTTOM LOCKNUTS FIG. 1C 02 35 SELF TAPPING SHOULDER BOLTS 2 2 COVER SEAL (See Fig. Align mark on seal with mark at cover opening. Work seal into opening so cover sits between flanges of seal. 4 MOUNTING TO TRACTOR (See Fig. 4) Use Hardware - - GROUP "C & D" 8 020 6 ALIGNMENT MARKS NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting assembly to tractor. Raise seat on tractor to allow assembly to be mounted. With cover closed, lift assembly and place support post inside mounting bracket. Allow assembly to rest on lanced tabs of mounting bracket. Line up holes in mounting bracket with holes in support post and insert bracket support pin. Secure cover assembly to support tube using short hex bolt, long hex bolt, and locknuts as shown. NOTE: Hardware securing support tube to drawbar must be tightened at this time. Install the four (4) tubing end caps onto container support. [. . . ] · Place attachment clutch in "DISENGAGED" position. · Turn ignition key "OFF" and remove key. · Make sure the blade and all moving parts have completely stopped. · Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. NOTE ON SOME MODEL TRACTORS, MINOR MODIFICATIONS MAY BE NECESSARY TO MOUNT YOUR NEW GRASS CATCHER. [. . . ]