User manual POULAN PRO PP1000E

[. . . ] R ENGLISH ESPAÑOL Instruction Manual Manual de Instrucciones Manuel d'Instructions PP1000E WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. [. . . ] S If blade strikes a foreign object, follow these steps: stop unit and disconnect spark plug wire (or disconnect from power source), inspect for damage, and repair any damage before resuming operation of the unit. 3 EDGING SAFETY WARNING: Inspect the area to be edged before each use. Remove objects (rocks, broken glass, nails, wire, string, etc. ) which can be thrown by the blade or can wrap around the shaft. S Keep others including children, animals, bystanders, and helpers at least 50 feet (15 meters) away. Stop the unit immediately if you are approached. Do not overreach or stand on unstable surfaces. S Always keep the wheel in contact with the ground. S Keep all parts of your body away from the blade and muffler. Thrown Objects Safety Glasses Boots S Always push the unit slowly over the ground. Stay alert for uneven sidewalks, holes in the terrain, large roots, etc. Use only for jobs explained in this manual. S To reduce the risk of fire, do not allow excessive grass, leaves, or grease to accumulate on the attachment. S Objects struck by the cutting member can cause serious injuries to persons. The lawn should always be carefully examined and cleared of all objects prior to edging. S Never operate without blade shield in place. WARNING: Blades can throw objects violently. D Wear safety glasses and boots. WARNING: Hazard zone for thrown objects. D Keep people and animals 50 feet (15 m) away. Blades move momentarily after the trigger is released. Allow blades to stop before removing them from the cut. WARNING: Blades move momentarily after the trigger is released. D The blades can seriously cut you or others. D Allow blades to stop before removing them from the cut. WARNING: Instruction Manual Safety Decals Read Instruction Manual. D Failure to do so can result in serious injury. TRANSPORTING AND STORAGE S Do not grasp or hold exposed blade. S Stop powerhead before leaving work area. S Allow powerhead and gearbox to cool before storing or transporting it in a vehicle. [. . . ] 9. Blade Blade nut Shaft Install new blade onto blade shaft. Reinstall both washers and blade nut (counterclockwise). Tighten blade nut firmly with a wrench while holding screwdriver in position. If the blade binds against the shield, or appears to be uneven, the blade is not centered, and you must reinstall. Screwdriver 8 STORAGE steps after each use: S Allow attachment and gearbox to cool before storing or transporting. [. . . ]