User manual POULAN PRO PP196

[. . . ] ENGLISH ESPAÑOL R Operator's Manual Manual del Operador Manuel de l'utilisateur PP196 UL R For Occasional Use Only IMPORTANT MANUAL - Do not throw away MANUAL IMPORTANTE - No lo descarte MANUEL IMPORTANT - À Conserver DANGER: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA: Lea el manual del operador y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. [. . . ] Slide the blade and retaining washer onto This engine is certified to operate on unleaded the shaft of the gearbox. Gasoline must be mixed with a good Now place the cupped washer onto the quality 2-cycle air-cooled engine oil designed to shaft. Make sure the cupped side of the be mixed at a ratio of 40:1. Poulan/Weed Eater washer is toward the blade. (A 40:1 ratio is obInstall the blade nut by threading onto the tained by mixing 3. 2 ounces of oil with 1 gallon of shaft counterclockwise. When mixing fuel follow the instructions printed on the container. Always read and follow the safety rules under FUEL SAFETY. Shield Dust Cup Threaded Shaft STARTING HOW TO STOP YOUR UNIT To stop the engine, move the ON/STOP switch to the STOP position (toward the cutting head). ON ON/STOP Switch Retaining Washer Cupped Washer Nut Blade Throttle Trigger STOP STARTING YOUR ENGINE NOTE: Make sure all parts are in place as il- lustrated, and the blade is sandwiched between the dust cup and the retaining washer. There should be no space between the blade and the dust cup or the retaining washer. S Align hole in the dust cup with the hole in the side of the gearbox by rotating the blade. S Insert a hex wrench into the aligned holes. This will keep the shaft from turning while tightening the blade nut. WARNING: The blade or trimmer head will turn while starting the engine. NOTE: A special feature called the "throttle lock" holds the throttle trigger in the depressed position during starting. S Lock throttle trigger into the starting postion by first pressing the lock--out lever on the top of the control handle. While the lock--out lever is depressed, squeeze and hold the throttle trigger. Lock Button Lock--out Lever Throttle Trigger 7 S Before releasing the throttle trigger, press the lock button. While this button is still deUSING YOUR pressed release the throttle trigger. NOTE: This should allow the throttle trigger to remain in the depressed position for start- OPERATING POSITION ing. You may want to practice this a few times before you first start the unit. S DO NOT squeeze throttle trigger during starting; otherwise, it will be necessary to reset the throttle lock. Starter Handle Control Handle in Right Hand UNIT Choke Primer Bulb Muffler COLD ENGINE STARTING (or warm engine after running out of fuel) S Rest engine and shield on ground, supporting trimmer head off ground. [. . . ] Expenses covered under warranty include diagnosis, parts and labor. MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by POULAN/WEED EATER. OWNER'S WARRANTY RESPONSIBILITIES: As the lawn and garden equipment engine owner, you are responsible for the performance of the required maintenance listed in your Owner's Manual. POULAN/WEED EATER recommends that you retain all receipts covering maintenance on your lawn and garden equipment engine, but POULAN/WEED EATER cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. [. . . ]