User manual POULAN PRO PP338PT

[. . . ] R ENGLISH Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. poulan-pro. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL PP338PT For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] Poulan or Poulan PRO oil resists high temperature thinning. If Poulan or Poulan PRO bar and chain oil is not available, use a good grade SAE 30 oil. S Never use waste oil for bar and chain lubrication. S Always stop the engine before removing the oil cap. If your engine still does not start after following these instructions, please call 1- 800- 554- 6723. - HELPFUL TIP until the engine has started and runs. Move the start lever to the START position. Starter Handle Primer Bulb STARTING A COLD ENGINE NOTE: DO NOT squeeze the throttle trigger Throttle Trigger Start Lever 4. 5. Muffler Pull starter rope handle sharply until engine starts and runs. Allow unit to run for 10-15 seconds, then fully squeeze the throttle trigger to disengage the starting system. HOW TO STOP YOUR UNIT S Release the throttle trigger. S Push and release the engine ON/STOP switch. The switch will automatically return to the ON position. Wait 5 seconds before attempting to restart unit to allow switch to reset. Pull starter rope sharply while squeezing throttle trigger until engine runs. NOTE: Normally, the warm starting procedure can be used within 5-10 minutes after the unit is turned off. If the unit sits for more than 10 minutes without being ran, it will be necessary to start the unit by following the steps under STARTING A COLD ENGINE or following the starting instruction steps shown on the unit. STARTING A WARM ENGINE STARTING A FLOODED ENGINE ON/STOP Switch Move the start lever to the RUN position and fully squeeze throttle trigger. Pull the starter handle repeatedly while squeezing throttle trigger until engine starts and runs. This could require pulling the starter handle many times, depending on how badly the unit is flooded. If the unit still doesn't start, refer to TROUBLESHOOTING TABLE or call 1-800-554-6723. OPERATING THE COUPLER HOW TO START YOUR UNIT WARNING: Make sure the chain will not make contact with any object while starting the engine. Never try to start the unit when the guide bar is in a cut. A hot muffler can cause serious burns. 13 This model is equipped with a coupler which enables optional attachments to be installed. The optional attachments are: MODEL: Edger . PP4000C Always stop unit and disconnect spark plug before removing or installing attachments. WARNING: stated in the applicable attachment instruction manual. Using the wrong hole could lead to serious injury or damage to the unit. tachments, place the unit on a flat surface for stability. [. . . ] OWNER'S WARRANTY RESPONSIBILITIES: As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your instruction manual. Poulan PRO recommends that you retain all receipts covering maintenance on your small off-road engine, but Poulan PRO cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should be aware that Poulan PRO may deny you warranty coverage if your small off-road engine or a part of it has failed due to abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your 24 small off-road engine to an Poulan PRO authorized repair center as soon as a problem exists. [. . . ]