User manual POULAN PRO PP400E

[. . . ] ENGLISH R Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. www. poulan-pro. com 1-800-554-6723 Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL FRANÇAIS PP400E WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. [. . . ] Check oil level after every 15 minutes of operation. CHAIN BRAKE Ensure chain brake is disengaged by pulling the front hand guard back toward the front handle as far as possible. The chain brake must be disengaged before cutting with the saw. STOPPING YOUR SAW S Release the trigger switch. S If motor does not stop, disconnect the extension cord. Discontinue use of the unit until it has been repaired by an authorized service dealer. Connect the saw to a power source using the proper size extension cord; see SELECT AN EXTENSION CORD). Push and hold the trigger lock-out button with your right hand thumb. CHAIN BRAKE WARNING: If the brake band is worn too thin it may break when the chain brake is triggered. With a broken brake band, the chain brake will not stop the chain. The chain brake must be replaced if any part is worn to less than 0. 020 (0. 5 mm) thick. Repairs on a chain brake should be made by your authorized service dealer. Take your unit to the place of purchase or to the nearest authorized service dealer. S This saw is equipped with a chain brake. The brake is designed to stop the chain if kickback occurs. S The inertia--activated chain brake is activated if the front hand guard is pushed forward, either manually (by hand) or automatically (by sudden movement). S If the brake is already activated, it is disengaged by pulling the front hand guard back toward the front handle as far as possible. S When cutting with the saw, the chain brake must be disengaged. Disengaged Engaged Braking function control CAUTION: The chain brake must be checked several times daily. The motor must be running when performing this procedure. This is the only instance when the saw should be placed on the ground with the motor running. Grip the rear handle with your right hand and the front handle with your left hand. Squeeze trigger switch and allow motor to reach full speed. [. . . ] CHAIN ADJUSTMENT See CHECK CHAIN TENSION in the MAINTENANCE section. CUSTOMER SERVICEABLE PARTS WARNING: Use of any other accessory or attachment might present a risk of injury to the operator. REPLACEMENT PART PART NO. 530015917 530053072 530016265 530053068 952055085 952051338 952044418 952030203 952030204 Hex Nuts Oil Cap Bar Adjusting Screw Bar Adjusting Pin File (5/32 dia. ) Twin Pak Xtra GUARDr Chain -18 Lo-Kickr Guide Bar - 18 Bar & Chain Lubricant - qt. -1 CUTTERS MUST FACE IN DIRECTION OF ROTATION Cutters Depth Gauge Drive Links 14 STORAGE WARNING: Perform the following steps after each use: S Allow motor to cool before storing or transporting. S Store chain saw and extension cord in a well ventilated area S Store chain saw with all guards in place and position chain saw so that any sharp object cannot accidentally cause injury. [. . . ]