User manual POULAN PRO PPB100

[. . . ] R ENGLISH ESPAÑOL Instruction Manual Manual de Instrucciones Manuel d'Instructions PPB100 For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. [. . . ] DO NOT USE automotive oil or marine oil. When mixing fuel, follow instructions printed on container. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit. BEFORE STARTING ENGINE WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not attempt to fuel your unit. Call 1-800-554-6723. FUELING ENGINE WARNING: when refueling. Remove fuel cap slowly IMPORTANT Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. See the STORAGE section for additional information. HELPFUL TIP To obtain the correct oil mix ratio, pour 3. 2 ounces of 2-cycle synthetic oil into one gallon of fresh gas. This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand synthetic oil is recommended. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by 8 HOW TO STOP YOUR UNIT S To stop the engine, move the ON/OFF switch to the OFF position. S If engine does not stop, move choke lever to FULL CHOKE position. 6. Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times. As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE by aligning lever with position shown on decal (see illustration below). ON/OFF Switch HOW TO START YOUR UNIT Choke position decal WARNING: Avoid any contact with the muffler. HELPFUL TIP If your engine still does not start after following these instructions, please call 1-800-554-6723. STARTING A COLD ENGINE (or a warm engine after running out of fuel) Starting Position Starter Handle Choke Lever Primer Bulb 8. Pull starter rope sharply until engine runs, but no more than 6 pulls. If the engine doesn't start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. [. . . ] OWNER'S WARRANTY -road enRESPONSIBILITIES: As the small offgine engine owner, you are responsible for the performance of the required maintenance listed in your instruction manual. ELECTROLUX HOME PRODUCTS, INC. , recommends that you retain all receipts covering maintenance on your small off-road engine, but ELECTROLUX HOME PRODUCTS, INC. , cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine engine owner, you should be aware that ELECTROLUX HOME PRODUCTS, INC. , may deny you warranty coverage if your small off-road engine engine or a part of it has failed due to abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your small off-road engine to an ELECTROLUX HOME PRODUCTS, INC. , authorized repair center as soon as a problem exists. [. . . ]