User manual POULAN PR524

[. . . ] IMPORTANT MANUAL Do Not Throw Away OWNER'S MANUAL MODEL NUMBER: PR524 SNOW THROWER Read the Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in serious injury. WARNING: Always Wear Eye Protection During Operation 415242 Rev 2 09. 24. 07 SR Printed in U. S. A. Safe Operation Practices for Walk-Behind Snow Throwers This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury. Look for this symbol to point out important safety precautions. [. . . ] If temperature is above 50°F, priming is not necessary. NOTE: Over priming may cause flooding, preventing the engine from starting. If you do flood the engine, wait a few minutes before attempting to start and DO NOT push the primer. When the engine starts, release the recoil starter handle and slowly move the choke control to the "OFF" position. Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operating temperature. WARM START Follow the steps above, keeping the choke in the "OFF" position. BEFORE STOPPING Run the engine for a few minutes to help dry off any moisture on the engine. IF RECOIL STARTER HAS FROZEN If the recoil starter has frozen and will not turn the engine, proceed as follows: 1. Grasp the recoil starter handle and slowly pull as much rope out of the starter as possible. Release the recoil starter handle and let it snap back against the starter. If the engine still fails to start, repeat the above steps. SNOW THROWING TIPS · · · · · · · · · · · Always operate the snow thrower with the engine at full throttle. Full throttle offers the best performance. Go slower in deep, freezing or heavy wet snow. Use the drive speed control, NOT the throttle, to adjust speed. It is easier and more efficient to remove snow immediately after it falls. The best time to remove snow is the early morning. At this time the snow is usually dry and has not been exposed to the direct sun and warming temperatures. Slightly overlap each successive path to ensure all snow will be removed. Adjust the skid plates to proper height for current snow conditions. See "TO ADJUST SKID PLATES" in this section of this manual. For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly. [. . . ] Failure to do so could be hazardous, damage your snow thrower and void your warranty. 29 REPAIR PARTS WHEELS / DECALS SNOW THROWER - MODEL PR524 (96192001501) 1 2 5 4 6 7 5 7 3 6 2 7 1 2 4 9 8 6 5 1 3 30 7 REPAIR PARTS WHEELS / DECALS SNOW THROWER - MODEL PR524 (96192001501) KEY PART NO. NO. DESCRIPTION 1 2 3 4 5 6 7 187831X421 155443 187866X421 146315 179830 174697 17490508 Wheel Assembly, 13", LH Pin, Klik 1/4 Wheel Assembly, 13", RH Screw, Hex Head 5/16-18 x 3/4 Bearing, Axle Washer, Thrust (1") Bolt KEY PART NO. NO. DESCRIPTION 1 2 3 4 5 6 7 8 9 --- 181037 187868 181035 181042 187893 181033 415391 415390 415475 415242 415243 Decal, Danger Decal, Poulan Pro, HP/24" Decal, Danger, Deflector Decal, Danger Decal, Poulan Pro Decal, Instruction Decal, Traction Lever Decal, Auger Lever Decal, Speed Control Owner's Manual, English Owner's Manual, French NOTE: All component dimensions given in U. S. [. . . ]