User manual POULAN PR600Y22RHP

[. . . ] SELF-PROPELLED ROTARY LAWN MOWER WARNING: This lawn mower is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the state of California the above is required by law (Section 4442 of the California Public Resources Code). A spark arrester for the muffler is available through your nearest authorized service center. 193733 Rev. [. . . ] Move the lever all the way forward to the CHOKE position when starting a cold engine. SLOW · Reinstall wheel components in the same order as they were before removal. · Make sure all wheels are at same height. Flat washer "AUTO WALK" or "VARI-SPEED" MODELS: · Remove drive cover and belt keeper. · Remove belt from gearcase pulley by pushing down on pulley and rolling belt off it. See engine manual for proper direction of turning over the engine. · Remove blade and debris shield. · Remove belt from engine pulley on crankshaft. · Install new belt by reversing above steps. NOTE: Always use factory approved belt to assure fit and long life. MODELS WITH GEARCASE-MOUNTED BELT KEEPER AND DEBRIS SHIELD: · Remove drive cover and belt keeper. · Remove belt from gearcase pulley. See engine manual for proper direction of turning over the engine. · Remove blade, engine pulley and debris shield. · Remove belt and engine pulley from debris shield. · Install new belt by reversing above steps. NOTE: Always use factory approved belt to assure fit and long life. Wheel Bolt Spacer 3/8-16 Locknut Drive cover Drive cover Belt Gearcase pulley FAST Belt keeper CHOKE (START) Remote throttle control MODELS WITH FIXED SPEED ENGINES Engine speed was set at the factory for optimum performance. Engine speed is not adjustable. MODELS WITH "QUICK ADJUST" WHEEL HEIGHT ADJUSTERS NOTE: For shipping purposes, the rear wheels on your lawn mower may not be adjusted to the same position as the front wheels. Before operating mower adjust all wheels to the same cutting height. · Raise wheels for low cut and lower wheels for high cut. · Adjust cutting height to suit your requirements. · To change cutting height, squeeze adjuster lever toward wheel. Move wheel up or down to suit your requirements. Be sure all wheels are in the same setting. NOTE: Adjuster is properly positioned when plate tab inserts into hole in lever. [. . . ] Always mulch with your highest engine (blade) speed as this will provide the best recutting action of the blades. · Avoid cutting your lawn when it is wet. Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early afternoon. [. . . ]