User manual POWAKADDY TOUCH QUICK GUIDE

[. . . ] Now plug the charger into the mains and leave for 24 hours to activate it. Meanwhile, take time to read this manual and learn about your exciting new purchase. for a "Quick Start" use the card inside the back cover of this guide. The PowaKaddy RoboKaddy compromises of a one piece machine that "snaps" into place in two easy moves, an antenna, handset, zero tip wheel, battery and charger. [. . . ] This is particularly important when using the left/right keys whilst stationary. If you keep trying you will overload the motors. Do not keep your finger pressed on any key for more than 5 seconds as this could cause damage to your RoboKaddy. G G G G 5 Special Features Your RoboKaddy is fitted with some special features to give you maximum control and adaptability. However it is worth reading the instructions now to familiarise yourself with the range of features available to you. LED Signal Indicators Your RoboKaddy is fitted with three sophisticated LED signal indicators one on the handset, one on the handle and one on the base controller under the battery tray. These will help you to diagnose any problems with interference or other problems. The handle LED will blink green in time with your handset LED when all is well and the machine is receiving a signal with the correct frequency and code. Should the machine pick up interference from the same frequency but the wrong code the LED will flash red. If you get the red flashing LED look for possible causes as defined in "trouble shooting". On the base controller near the trimmer knob is another LED, this indicates as follows ­ LED flashing green indicates that all is well and that the machine is working properly. The LED will only stop flashing when the main battery is disconnected. You will need to experiment to get the perfect line, a bit like golf really!NOTE ­ The degree of turn may vary from one side to the other depending on bag load and course conditions. PowaKaddy Customer Care 01795 473 555 7 Questions and Answers How do I switch the trolley from manual control to remote control?a) Simply start to use the handset with the plus key the trolley will automatically switch to remote mode. How do I regain manual control from remote mode?a) b) c) d) Press the brake key to turn off the handset. Turn the rotary speed control knob to off. Turn the rocker switch off (O) then on (I). Turn the rotary speed control knob to the desired setting. How do I use the trolley in manual mode from the start?a) b) c) d) Turn the rotary speed control knob to "off". Turn the rocker switch on (I) then off (O) then (I). Turn the rotary speed control knob and adjust to the desired setting. How do I brake the trolley on a downhill slope when in remote mode?a) Press the brake key once and the motors will stop. [. . . ] You cannot stop this process; but you can prolong it's life. Conversely, incorrect treatment can cause irreversible damage. When you get your brand new battery, put it on charge for 24 hours to "activate" it. For the first three outings you may find that your RoboKaddy is a little tired at the end of the round, this is normal and will be fine once the battery has reached full power, normally after three rounds. [. . . ]