User manual POWERBUILT 647376

[. . . ] Model #647376 TWIN TANK AIR COMPRESSOR 5 Gallon / 3 Peak HP 226892 If you encounter any problems or difficulties, Do not return your compressor to the store!Please contact our toll-free customer service department at: 1-800-423-3598 · 1-310-522-9008 (California Only) · www. alltradetools. com It is the owner and/or operator's responsibility to study all WARNINGS, operating, and maintenance instructions contained on the product label and instruction manual prior to operation of this unit. The owner/operator shall retain product instructions for future reference. The owner and/or operator is responsible for maintenance, maintaining all decals or warning labels and while in use, maintaining the unit in good working order. [. . . ] If your application's demands exceed the capacity of this air compressor, a larger air compressor that is matched to your application is recommended. If the unit shuts down again, please call the consumer helpline at 1-800-423-3598 for assistance. CARRY HANDLE: Convenient handle for easy transport. 13 ASSEMBLY INSTRUCTIONS THE COMPRESSOR IS SHIPPED WITHOUT OIL IN THE CRANKCASE. ADD OIL AS INDICATED BELOW. STEP 1 ­ PUMP LUBRICATION This air compressor features an oil lubricated pump that requires the use of SAE 30 weight non-detergent air compressor oil. Place air compressor on a flat, level surface. Remove RED plastic oil fill breather plug (see Fig. Open supplied oil bottle and pour oil into crankcase until the oil level reaches the center of the red circle in the oil level sight glass (see Fig. 2 CAUTION CHECK OIL LEVEL DAILY! OIL LEVEL OK REFILL OIL IMMEDIATELY OIL CAPACITY: 28oz 4. See diagram for determining proper oil fill level using oil fill sight glass (see Fig. Install supplied RED plastic oil fill breather plug securely into oil fill hole. (833ml) Fig. 3 DO NOT OPERATE THE COMPRESSOR WITHOUT LUBRICANT, OR WITH LOW LUBRICATION LEVEL. THE MANUFACTURER IS NOT RESPONSIBLE FOR DAMAGE CAUSED TO THE COMPRESSOR DUE TO OPERATION WITHOUT PROPER LUBRICATION. 9 STEP 2 ­ INSPECTION CHECK Assembly Check: In order to complete the assembly of your new air compressor, a careful inspection should be made to ensure that all of the parts are properly aligned and securely fastened. Inspect air filter to ensure that it is installed and secure. OPERATION INITIAL SETUP / BREAK-IN PROCEDURE: Do not attach air hose, air tools or other air accessories to the air outlet until break-in procedure has been successfully completed. Read and understand the entire instruction manual, including all safety warnings before setting up air compressor. Place air compressor on a flat, level surface. Check oil fill level in crankcase and add oil as needed. Turn the pressure regulator knob fully clockwise to open airflow from air outlet port. Be careful not to overtighten pressure regulator knob when it "bottoms out" as this may damage pressure regulator. Turn the power switch to the OFF position. Plug power cord directly into a properly grounded power source of the correct voltage (see Grounding Instructions on page 5 of this instruction manual). Open the tank drain valve to allow air to escape preventing air pressure buildup in the air tank. [. . . ] Under no circumstances shall Alltrade bear any responsibility for loss of the unit, loss of time or rental, inconvenience, commercial loss or consequential damages. Exclusions This warranty does not cover parts damaged due to normal wear, abnormal conditions, misapplication, misuse, abuse, accidents, operation at other than recommended pressures or temperatures, improper storage or freight damage. Parts damaged or worn by operation in dusty environments are not warranted. Failure to follow recommended operating and maintenance procedures also voids warranty. [. . . ]