User manual POWERFIX KH 2902 MULTI-PURPOSE METAL DETECTOR

[. . . ] Do not use the appliance at locations where there is a risk of fire or explosion, e. This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. [. . . ] Lay the tape for removal of the battery underneath the 9V block battery and press it into the battery compartment 5. Ensure that the wires are not trapped in any way. Before using the appliance for this task, first test it by locating a pipeline or electrical power cable at a known position. In cases of doubt, always consult a qualified building contractor. To enable a power cable to be detected by the appliance, its circuit must be under power. If you wish to trace for example the cable route from light switch to lamp, switch the lamp on. Place the function switch 3 into the position METAL for locating metals and into the position VOLTAGE for locating power cables. Press the detector with the measuring head 2 vertically against the wall to be examined, then hold the button PUSH 4 down (the red LED 1 glows weakly). Now slowly slide the detector in this position over the wall. Should there be a metal object / a power cable close to the measuring head 2, the red LED 1 glows more brightly and several signal tones sound one after the other. In this case, release the button PUSH 4 and then press it again, to reactivate the detection process. The closer the measuring head 4 comes to the metal object / the power cable, the shorter is the interval between the signal tones. [. . . ] Every consumer is legally obliged to dispose of batteries at a collection site of his community/city district or at a retail store. The purpose of this obligation is to ensure that batteries are disposed of in a non-polluting manner. [. . . ]