User manual POWERFIX KH 4232 DRILL PUMP

[. . . ] Avoid the intake of coarse dirt, otherwise the pump could be damaged. If needs be, use a filter on the suction hose. This appliance is not intended for use by children or other individuals whose physical, sensorial or intellectual abilities prevent safe usage of the appliance should they not receive support or supervision in the correct operation of the appliance. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Let the drill u start to run in a clockwise rotation and at low revolutions and then guide the pump q straight onto the drive shaft e. When using a chuck with SDS fitting and the long drive shaft r. Attach the long drive shaft r into the chuck. µ Insert the electric drill u, with the pre-assembled drive shaft r in the chuck, into the mounting y. µ Now push the pump q onto the mounting y so that the drive shaft r µ µ Projects into the thread of the drive shaft w and the pins of the mounting y are located in the reception holes on the pump q. Allow the electric drill u to run with a clockwise rotation and low revolutions and guide the pump q straight on to the drive shaft r. With this the drive shaft r will be fixated onto the pump q. Wheel rim chuck µ Open the chuck with the chuck key through the recess i and then remove the pump q from the mounting y. µ Unscrew the short drive shaft e by using a cross-headed screwdriver and the open-ended spanner from the pump q. µ Using the open-ended spanner through the recess i, counter screw the µ Allow the electric drill u to run with an anti-clockwise rotation and low reµ Remove the pump q from the mounting y. Chuck with SDS fitting µ Using the open-ended spanner through the recess, i counter screw the drive shaft w of the pump q. µ Allow the electric drill u to run with an anti-clockwise rotation and low revolutions. With this the drive shaft r will be released from the pump q. If the pump q does not start to suck up within 12 seconds, turn the drill u off immediately to avoid seizure. For this same reason, do not allow the pump q to commence suction if the pressure hose on the discharge side is closed. The suction hose may not be longer than 3 m. ensure that the suction hose does not pull in air. If the pump q does not commence suction, fill the hose with some water and then lift it so that the liquid runs before the pump. µ Allow the drill u, now the pump q, to start-up ­ but not without supervision, So that you can react quickly in the event of danger. Absolutely ensure that the electric drill u is rotating to the right, as with normal drilling. Should the rotation speed of the electric drill u be adjustable, you can use this to regulate the discharge flow. Turn the drill off immediately after the container is empty. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. Your statutory rights are not restricted in any way by this warranty. The warranty period will not be extended by repairs made under warranty. [. . . ]