User manual POWERFIX KH 3236

[. . . ] Do NOT use the appliance to determine the alternating voltage level in exposed or non-insulated power cables. The appliance does not always recognise all pipes and power cables. The following conditions can contribute to inaccurate results: ­ very thick walls ­ weak battery ­ deeply laid power cables or pipework ­ shielded cables ­ thick walls with thin pipes or power cables ­ walls panelled with metal sheets ­ very moist conditions · This appliance is not suitable for detecting power cables in circuits, ­ which are isolated from the mains power supply. With this appliance pipework made of plastic or similar materials cannot be detected, only pipework made of metal. [. . . ] When you wish to leave the addition mode, press the button MODE 4. In the upper line the measured length appears and , , W" (Width) starts to flash. press the button READ 6 to measure the width. In the upper line the measured width appears and , , H" (Height) starts to flash. The appliance is now ready for the second measurement. The result of the first measurement is shown in the lower line. Both measurements are added together and the result is shown in the lower line. Repeat the steps 2 to 7 to add in further measurement values. When you wish to leave the addition mode, press the button MODE 4. Before using the appliance for this task, first test it by locating a pipeline or electrical power cable at a known position. ⷠIn cases of doubt, always ask a qualified building contractor. Under no circumstances should you drill at this location!The locating of concealed objects is the same in all three modes (STUD = wood, AC WIRE = live electric power cables, METAL = metal). First of all, the appliance must be calibrated. Place it flat against the wall where you wish to search for concealed objects. The appliance has now adjusted itself to the wall thickness. Move slowly along the wall with the appliance. As the arrows in the display move closer to the centre of the display, you are getting closer to the concealed object. When the arrows touch and a constant signal tone is heard, mark this position (see Fig. Now repeat the procedure, but this time approach the object from the other side. As soon as the signal tone sounds, mark this position (see Fig. The concealed object runs between these two positions. [. . . ] Only in this way can a post-free despatch for your goods be assured. The warranty covers only claims for material and manufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. [. . . ]