User manual PRESIDENT HARRY II CLASSIC

[. . . ] Take care not to damage the vehicle's electrical system while drilling the dash board. E) Choose where to place the microphone support and remember that the microphone cord must stretch to the driver without interfering with the controls of the vehicle. : As the transceiver has a frontal microphone socket, it can be set into the dash board. In this case, you will need to add an external loud speaker to improve the sound quality of communications (connector EXT. [. . . ] It is necessary to connect your CB to a permanent (+) and (-). We advise you to connect the power cable directly to the battery (as the connection of the CB cable to the wiring of the car-radio or other parts of the electrical circuit may, in somecases, increase the likelihood of interference). connect the red wire (+) to the positive terminal of the battery and the black (-) wire to the negative terminal of the battery. Connect the power cable to your CB radio. E) Go to Channel 20 using the rotary knob on the front panel. WARNING: In order to avoid any losses and attenuations in cables used for connection between the radio and its accessories, PRESIDENT recommends to use a cable with a length inferior to 3m. A) To turn the set on, turn the knob (1) clockwise b) To increase the sound level, turn the same knob further clockwise. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). The adjustment must be carried out in an obstacle-free area. SWR 1 or SWR 2): a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. Suppresses undesirable back-ground noises when there are no communication. Squelch does not effect neither sound nor transmission power, but allows a considerable improvement in listening comfort. This knob is for adjusting sensitivity during reception. For long distance communications RF GAIN should be set to maximum. RF GAIN can be reduced to avoid distortion, when your correspondent is close by and who does not have the RF POWER function. Turning this knob allows you to choose a channel (1-40) for transmitting and receiving. Turn the squelch knob clockwise to the exact point where all back-ground noise disappears. This adjustment should be done with precision as, if set to maximum, (i. The display shows all the different functions. [. . . ] Below you will find some of the most frequently used CB radio expressions. Remember this is meant for fun and that you are by no means obliged to use them. In an emergency, you should be as clear as possible. Advertising Back off Basement Base station Bear Bear bite Bear cage Big slab Flashing lights of police car Slow down Channel 1 A CB set in fixed location Policeman Speeding fine Police station Motorway Big 10-4 Bleeding Blocking the channel Blue boys Break Breaker Clean and green Cleaner channel Coming in loud and proud Doughnut Down and gone Down one Do you copy? [. . . ]