User manual PRESIDENT HARRY III

[. . . ] Power, antenna, accessory cabling) so that they do not in any way interfere with the driving of the vehicle. D) To install your equipment, use the cradle (1) and the self-tapping screws (2) provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. E) Do not forget to insert the rubber joints (3) between the CB and its support as these have a shock-absorbing effect which permits gentle orientation and tightening of the set. [. . . ] a) ASC: AUTOMATIC SQUELCH CONTROL Worldwide patent , a PRESIDENT exclusivity. Turn the SQ knob (2) anti-clockwise into ASC position. No repetitive manual adjustment and a permanent improvement between the sensitivity and the listening comfort when ASC is active. This function can be disconnected by turning the switch clockwise. B) MANUAL SQUELCH Turn the SQ knob clockwise to the exact point where all background noise disappears. This adjustment should be done with precision as, if set to maximum (fully clockwise), only the strongest signals will be received. A) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). The reading on the Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. Keep the key F pressed and switch on again. And the letter corresponding to the configuration are blinking. In order to change the configuration, use the channel selector on the front panel or the UP/DN keys of the microphone. When the configuration is selected, press 1 second on the F key. And the letter corresponding to the configuration are continuously displayed, a beep sounds. At this point, confirm the selection by switching off the transceiver and then switching it on again. This button allow increasing or decreasing a channel. A «beep» sounds each time the channel changes if the KEY BP function is activated. The VOX function allows transmitting by speaking into the original microphone (or in the optional vox microphone) without pressing the PTT switch. the use of an optional vox mike connected to the rear panel of the transceiver (C) disables the original microphone. Press shortly the VOX key in order to activate the VOX function. A new press on the VOX key disables the function «VOX» disappears. [. . . ] Press the «push-to-talk» switch and announce your message «Attention stations, transmission testing» which will allow you to check the clearness and the power of your signal. Release the switch and wait for a reply. you should receive a reply like , «Strong and clear». If you use a calling channel (19, 27) and you have established communication with someone, it is common practice to choose another available channel so as not to block the calling channel. [. . . ]