User manual PRESIDENT HARRY III CLASSIC

[. . . ] Power, antenna, accessory cabling) so that they do not in any way interfere with the driving of the vehicle. D) To install your equipment, use the cradle (1) and the self-tapping screws (2) provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. E) Do not forget to insert the rubber joints (3) between the CB and its support as these have a shock-absorbing effect which permits gentle orientation and tightening of the set. [. . . ] WARNING: In order to avoid any losses and attenuations in cables used for connection between the radio and its accessories, PRESIDENT recommends to use a cable with a length inferior to 3m. A) To turn the set on, turn the knob (1) clockwise. B) To increase the sound level, turn the same knob further clockwise. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). The adjustment must be carried out in an obstacle-free area. Squelch does not affect neither sound nor transmission power, but allows a considerable improvement in listening comfort. A) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). The reading on the Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. Turn the SQ knob clockwise to the exact point where all background noise disappears. This adjustment should be done with precision as, if set to maximum (fully clockwise), only the strongest signals will be received. The BARGRAPH shows the reception level and the output power level. In order to disable the function, press during 1 second the KEY BP key. For long distance communications RF GAIN should be set to maximum. You can reduce the RF GAIN in order to avoid distortion when your correspondent is close by and when he has no RF POWER. Allows to lock all the keys on the front pannel and the rotary knob. An error beep sounds when a key is used and the LOCK function is activated. This button allow increasing or decreasing a channel. A «beep» sounds each time the channel changes if the KEY BP function is activated. (configuration: E; d; EU; EC; U; PL) The frequency bands have to be chosen according to the country of use. Some countries need a user's licence. [. . . ] Remember this is meant for fun and that you are by no means obliged to use them. In an emergency, you should be as clear as possible. Advertising Back off Basement Base station Bear Bear bite Bear cage Big slab Big 10-4 Bleeding Blocking the channel Blue boys 37 Flashing lights of police car Slow down Channel 1 A CB set in fixed location Policeman Speeding fine Police station Motorway Absolutely Signal from an adjacent channel interfering with the transmission : Pressing the PTT switch without talking : Police : : : : : : : : : : Break Breaker Clean and green Cleaner channel Coming in loud and proud Doughnut Down and gone Down one Do you copy?DX Eighty eights Eye ball Good buddy Hammer Handle Harvey wall banger How am I hitting you? [. . . ]