User manual PRESIDENT JAMES

[. . . ] Before using, be careful never to transmit without first having connected the antenna (connection E situated on the back panel of the equip-ment) or without having set the SWR (Standing Wave Ratio) !Failure to do so may result in destruction of the power amplifier, which is not covered by the guarantee. Welcome to the world of the 3rd generation of CB radios. The new PRESIDENT INTERACTIVE range gives you access to top performance CB equipment. [. . . ] E) Press the «MTR» key, with the «pushto-talk» switch pressed down, so that the equipment is in S/RF mode. A) One quick press on this key turns your CB on and off. B) A longer depression (about three seconds) activates the protection by code procedure. The code must be re-entered to put the set on. NOTA : As soon as your set goes off, the last configuration is memorised ready for the next time. Il est alors nécessaire de saisir à nouveau ce dernier afin de remettre le poste en marche, a) To connect the SWR meter: - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type CA 2C PRESIDENT). A) Set turned off (but with power supply connected): By pressing the DIMMER key the flashes indicating message clearly and permanently the code protection in your absence. You should not leave this function on for more than three days without starting your vehicle's engine (risk of flat battery). Meter should b) Set turned on : be as near as possible to 1. if this is Adjusts the display's luminosity. Not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate after each adjustment of the antenna. With this key you can change the colour of the digital display to either amber or green, so that your set is in harmony with the interior of your vehicle. The two keys, «CH » and «CH » on the microphone and on the front panel, allow you to go up and down the channels. This can also be done with the channel rotary knob. «CH » key : one quick press allows you to go down by one channel, continued pression allows you to descend five channels per second. «CH » key : one quick press allows you to go up by one channel, continued pression allows you to ascend five channels per second. Suppresses undesirable background noise when there are no communications. Turn the squelch knob clockwise to the exact point where all background noise disappears. This adjustment should be done with precision as, if set to maximum, only the strongest of signals can be received. Squelch does not effect either sound or transmission power, but allows for considerable improvement in listening comfort. When you turn this knob fully clockwise the RF power (norm peak 4 watts) is at maximum. [. . . ] by rapidly pressing the «PROGRAM» key , P1 , P2 , P3 , P4 will show in the display. Pressing longer on one of the four keys (P1 - P4) will cause the display to flash. By immediately pressing one of the memory keys Used in conjunction with the «PROGRAM» key, these keys allow you to memorise and to call up information. It is also possible to define the four memorised channels by using the keys P1 - P4, thus giving - une pression sur la touche «M1» : arrête de clignoter M1 s'al- - Depression of «M1» : stops flashing, appears, lume, beep long Le Canal 22 FM est long beep sounds to indicate that stocké dans la case M1 Channel 22 FM is memorised . [. . . ]