User manual PRESIDENT JIMMY

[. . . ] D) To install your equipment, use the cradle (1) and the self-tapping screws [2] provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. E) Choose where to place the microphone support and remember that the microphone cord must stretch to the driver without interfering with the controls of the vehicle. : As the transceiver has a frontal microphone socket, it can be set into the dash board. [. . . ] You can check this by making sure that the negative terminal of the battery is connected either to the engine block or to the chassis. If this is not the case, you should consult your dealer. WARNING: Lorries generally have two batteries and an electrical installation of 24 volts, in which case it will be necessary to insert a 24/12 volt converter (type CV 24/12 PRESIDENT) into the electrical circuit. The following connection steps should be carried out with the power cable disconnected from the set. Should it be necessary to lengthen the power cable, you should use the same or a superior type of cable. C) It is necessary to connect your CB to a permanent (+) and (-). We advise you to connect the power cable directly to the battery (as the connection of the CB cable to the wiring of the car-radio or other parts of the electrical circuit may, in somecases, increase the likelihood of interference). d) Connect the red wire (+) to the positive terminal of the battery and the black (-) wire to the negative terminal of the battery. E) Connect the power cable to your CB radio. E) Go to Channel 20 using the rotary knob on the front panel. A) To turn the set on, turn the knob (1) clockwise b) To increase the sound level, turn the same knob further clockwise. Suppresses undesirable back-ground noise when there are no communications. Turn the squelch knob clockwise to the exact point where all background noise disappears. This adjustment should be done with precision as, if set to maximum, (i. Squelch does not effect either sound or transmission power, but allows for considerable improvement in listening comfort. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). The adjustment must be carried out in an obstacle-free area. SWR 1 or SWR 2): a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. Turning this knob allows you to choose a channel (1-40) for transmitting and receiving. [. . . ] If you use a calling channel (19, 27) and you have established communication with someone, it is common practice to choose another available channel so as not to block the calling channel. Advertising Back off Basement Base station Bear Bear bite Bear cage Big slab Big 10-4 Bleeding Blocking the channel Blue boys Break Breaker Clean and green Cleaner channel Coming in loud and proud Doughnut Down and gone Down one Do you copy?DX Eighty eights Eye ball Good buddy Hammer Handle Harvey wall banger How am I hitting you?Keying the mike Kojac with a kodak Land line Lunch box Man with a gun Mayday Meat wagon : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : Flashing lights of police car Slow down Channel 1 A CB set in fixed location Policeman Speeding fine Police station Motorway Absolutely Signal from an adjacent channel interfering with the transmission Pressing the PTT switch without talking Police Used to ask permission to join a conversation A CBer wishing to join a channel Clear of police Channel with less interference Good reception Tyre Turning CB off Go to a lower channel Understand? [. . . ]