User manual PRESIDENT JOHNNY III

[. . . ] Power, antenna, accessory cabling) so that they do not in any way interfere with the driving of the vehicle. D) To install your equipment, use the cradle (1) and the self-tapping screws (2) provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. E) Do not forget to insert the rubber joints (3) between the CB and its support as these have a shock-absorbing effect which permits gentle orientation and tightening of the set. [. . . ] The adjustment must be carried out in an obstacle-free area. TOS-1 PRESIDENT) a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). The reading on the Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. Squelch does not affect neither sound nor transmission power, but allows a considerable improvement in listening comfort. worldwide patent , a PRESIDENT exclusivity. Turn the SQ knob (2) anti-clockwise into ASC position. No repetitive manual adjustment and a permanent improvement between the sensitivity and the listening comfort when ASC is active. This function can be disconnected by turning the switch clockwise. B) MANUAL SQUELCH Turn the SQ knob clockwise to the exact point where all background noise disappears. This adjustment should be done with precision as, if set to maximum (fully clockwise), only the strongest signals will be received. Keep the key F pressed and switch on again. And the letter corresponding to the configuration are blinking. In order to change the configuration, use the channel selector on the front panel. When the configuration is selected, press 1 second on the F key. And the letter corresponding to the configuration are continuously displayed, a beep sounds. At this point, confirm the selection by switching off the transceiver and then switching it on again. The BARGRAPH shows the reception level and the output power level. In order to disable the function, press during 1 second the KEY BP key. For long distance communications RF GAIN should be set to maximum. You can reduce the RF GAIN in order to avoid distortion when your correspondent is close by and when he has no RF POWER. [. . . ] If you use a calling channel (19, 27) and you have established communication with someone, it is common practice to choose another available channel so as not to block the calling channel. Below you will find some of the most frequently used CB radio expressions. Remember this is meant for fun and that you are by no means obliged to use them. In an emergency, you should be as clear as possible. [. . . ]