User manual PRESIDENT NINJA

[. . . ] D) To install your equipment, use the cradle (1) and the self-tapping screws [2] provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. F) Choose where to place the microphone support and remember that the microphone cord must stretch to the driver without interfering with the controls of the vehicle. : As the transceiver has a frontal microphone socket, it can be set into the dash board. [. . . ] d) Connect the red wire (+) to the positive terminal of the battery and the black (-) wire to the negative terminal of the battery. E) Connect the power cable to your CB radio. F) Go to Channel 20 using the rotary knob on the front panel or UP / DOWN button on microphone (4). A) To turn the set on, turn the knob (1) clockwise b) To increase the sound level, turn the same knob further clockwise. Suppresses undesirable back-ground noises when there are no communication. Squelch does not effect neither sound nor transmission power, but allows a considerable improvement in listening comfort. A) ASC: Automatic Squelch Control Worldwide patent, a PRESIDENT exclusivity No repetitive manual adjustment and a permanent improvement in listening comfort when this function is active. It can be disconnected by turning the switch (2) clockwise, in this case the manual squelch control becomes active again. B) Turn the squelch knob clockwise to the exact point where all back-ground noise disappears. This adjustment should be done with precision as, if set to maximum, (i. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). The adjustment must be carried out in an obstacle-free area. SWR 1 or SWR 2): a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. The display shows all the different functions. FUNCTION activated AM mode FM mode SCAN mode ANL mode LOCK : key lock enabled NB mode DW : dual watch activated RX: receipt mode channel number or channel frequency or frequency band preset memory channels ASC mode the received signal strength and the power of the transmitting signal transmission mode Press the F key during approximately 2 seconds, you may then select either frequency display or channel number. With this control, you can automatically seek a busy channel. These filters allow the reduction of back ground noise, and some reception interference. AM Mode (NB and ANL active) Press this key once to activate the NB filter. A second depression of the same key activates ANL. [. . . ] Remember this is meant for fun and that you are by no means obliged to use them. In an emergency, you should be as clear as possible. Advertising Back off Basement Base station Bear Bear bite Bear cage Big slab : : : : : : : : Flashing lights of police car Slow down Channel 1 A CB set in fixed location Policeman Speeding fine Police station Motorway 35 Blocking the channel : Blue boys : Break : Breaker : Clean and green : Cleaner channel : Coming in loud and proud: Doughnut : Down and gone : Down one : Do you copy?: DX : Eighty eights : Eye ball : Good buddy : Hammer : Handle : Harvey wall banger : How am I hitting you? [. . . ]