User manual PRESIDENT PM-2010 WP

[. . . ] In case of exposure to cell contents, wash the affected area thoroughly, and seek medical attention. The Lithium Ion Battery Pack contained in this equipment may explode if disposed of in a fire. Do not charge the Lithium Ion Battery Pack used in this equipment in any charger other than the one designed to charge this Battery Pack. Using another charger may damage the Battery Pack or cause the Battery Pack to explode. [. . . ] To listen to a weak or distant station, turn the knob counterclockwise. If reception is poor, turn it clockwise to cut out weak transmissions. If the squelch control is adjusted so you continually hear a hissing sound, the unit will not scan properly. To turn Off the unit, turn the Volume / Power knob counterclockwise until it clicks. Seagoing / Inland Mode Seagoing Mode Transmit power is limited to low at channels 75 and 76 in Seagoing mode. Inland Mode Transmit power is limited to low at channels 6, 8, 10 to 15, 17, 71, 72, 74, 75, 76, and 77 in Inland mode. Set Seagoing / Inland Mode Turn on the radio while pushing and holding 1/5W and 16/9 keys, "Inland Mode" or "Seagoing Mode" are switched. One-touch Emergency Channel 16/9 Example: While you are monitoring channel 20, you want to check EMG channel 16 or EMG channel 9. To exit from Triple Watch, press again the TRI button. While in Triple Watch mode, you can change the currently selected channel using the or button. A momentary press of the 16/9 button interrupts Triple Watch mode and remains on 16, or on channel 9 if you press once more. To return to the previous mode, simply press the button again. It becomes Dual Watch when Triple Watch function is turned on while CH9 or CH16 is displayed. Programming a Channel into Memory Before using the scanning feature, you have to program channels into memory. Scanning starts from the lowest to highest channel and stops when it finds an active channel. It remains on that channel until the transmission ends, then resumes scanning after a 3 second delay period. When in the scan mode, the unit automatically activates the Triple Watch feature. Transmission power can be set to either 5W or 1W. Press the 1/5W button to make the change, then the "5W" or the "1W" indicator on the display changes accordingly. TX Power will be set to 5W when is changed to 16CH. [. . . ] This transceiver has a 3 years warranty for materials and workmanship in its country of purchase against any manufacturing defect recognized by our technical department. It is recommended to read carefully following conditions and to respect them in order not to loose it. Any repair under warranty will be free of charge and the transport costs for sending back will be on charge of our company. A proof of purchase must compulsorily be added to the transceiver in need of repair. [. . . ]