User manual PRESIDENT TAYLOR II CLASSIC

[. . . ] D) To install your equipment, use the cradle (1) and the self-tapping screws [2] provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. E) Do not forget to insert the rubber joints [3] between the CB and its support as these have a shock-absorbing effect which permits gentle orientation and tightening of the set. F) Choose where to place the microphone support and remember that the microphone cord must stretch to the driver without interfering with the controls of the vehicle. [. . . ] The following connection steps should be carried out with the power cable disconnected from the set. Should it be necessary to lengthen the power cable, you should use the same or a superior type of cable. C) It is necessary to connect your CB to a permanent (+) and (-). We advise you to connect the power cable directly to the battery (as the connection of the CB cable to the wiring of the car-radio or other parts of the electrical circuit may, in somecases, increase the likelihood of interference). d) Connect the red wire (+) to the positive terminal of the battery and the black (-) wire to the negative terminal of the battery. E) Connect the power cable to your CB radio. E) Go to Channel 20 using the rotary knob on the front panel. A) To turn the set on, turn the knob (1) clockwise b) To increase the sound level, turn the same knob further clockwise. Suppresses undesirable back-ground noises when there are no communication. Squelch does not effect neither sound nor transmission power, but allows a considerable improvement in listening comfort. Turn the squelch knob clockwise to the exact point where all back-ground noise disappears. This adjustment should be done with precision as, if set to maximum, (i. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). The adjustment must be carried out in an obstacle-free area. SWR 1 or SWR 2) a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. WARNING: In order to avoid any losses and attenuations in cables used for connection between the radio and its accessories, PRESIDENT recommends to use a cable with a length inferior to 3m. Turning this knob allows you to choose a channel (1-40) for transmitting and receiving. The modulation mode must correspond with that of the person with whom you communicate. A/ Amplitude Modulation (AM) is for communications in areas where there are obstacles and over medium distances. [. . . ] you should receive a reply like , «Strong and clear». If you use a calling channel (19, 27) and you have established communication with someone, it is common practice to choose another available channel so as not to block the calling channel. Advertising Back off Basement Base station Bear Bear bite : : : : : : Flashing lights of police car Slow down Channel 1 A CB set in fixed location Policeman Speeding fine Blocking the channel : Blue boys : Break : Breaker : Clean and green : Cleaner channel : Coming in loud and proud : Doughnut : Down and gone : Down one : Do you copy?: DX : Eighty eights : Eye ball : Good buddy : Hammer : Handle : Harvey wall banger : How am I hitting you? [. . . ]