User manual PRIMA GHH100

[. . . ] The fan heater must not be located immediate below a socket ­ outlet. Do not use this fan heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. Only use the fan heater with it standing on its base or using the mounting bracket. Always turn the appliance off, unplug it and allow the whole unit too cool down before moving the unit, cleaning it or whenever it is not in use. [. . . ] Do not place the appliance in a position where the mist will come into direct contact with furniture, carpets, curtains or walls. Do not attempt to use the humidifier if the water is frozen, allow it to thaw at room temperature. GETTING TO KNOW YOUR HEATER/HUMIDIFIER 1. Vapor cover/outlet POWER LIGHT (1) 2. Water outlet When illuminated, indicates that the heater or humidifier is powered. When extinguished, indicates that the unit has been switched off. MAIN CONTROL (3) This Control is used to turn your Heater/Humidifier ON or OFF. Also, there are other functions for the control and they are shown as follows: Position I II III IV V VI VII Functions OFF Activate the fan only (for Summer use) Activate the heater to medium heat Activate the heater to maximum heat Activate the humidifier and the fan Activate the humidifier & heater with medium heat Activate the humidifier & heater with maximum heat THERMOSTAT CONTROL (2) The heat output is controlled by the thermostat, according to room temperature. Set the dial to the number you wish (* is the minimum "approximately 6oC, and 10 is the maximum " approximately 35oC"). When the room temperature is reached, the heater will turn off automatically to maintain your selected temperature. When the temperature drops, the thermostat will click on the appliance again. The appliance will keep turning ON and OFF. The turning off position "O" on the main control must be selected in order to shut down the unit permanently. WATER TANK The water tank for the humidifier is located inside the fan heater, which can not be removed. The fill the water tank : 1) 2) 3) Turn the unit off, unplug the main cord and allow the whole appliance to cool down. Open the vapor cover/outlet (9) carefully add cold tap water into the water inlet. When the water level indicator is showing maximum stop adding water into the tank and close the vapor cover/outlet. when the water is filled exceeding the maximum level, excess water will pour out from the water drain outlet (10). Do not add water into the tank by placing the fan heater directly under the tap. Note: MOUNTING THE FAN HEATER ON A WALL A mounting bracket (6) is provided for each individual unit, two 4mm diameter screws are needed for fixing the bracket on a wall "the flat side of the bracket face to the wall" and ensure that the bracket is fixed on the wall firmly. [. . . ] during the summer months), it is important that you follow these instructions to help prevent stagnation of water in the unit. Clean your Fan Heater as instructed in the section titled "Cleaning". Make sure all water is emptied from the tank. Water can be poured out from either the vapor cover/outlet (9) or the water outlet (10). [. . . ]