User manual PRIMA SFH7000

[. . . ] To disconnect the heater, put the control to (0) OFF, then unplug from the mains, TO UNPLUG THE APPLIANCE, PULL THE PLUG, NOT THE CABLE. Do not use a heater with a damaged plug or power cable, or after a malfunction, or if it has been dropped or suffered any kind of damage. Return the heater to the authorised repair centre closest to you so that it can be examined, electrical or mechanical adjustments made, or repaired. This heater is not designed for use in damp or wet places, such as bathrooms or clothes washing areas. [. . . ] The manufacturer does not recommend any other use, as it could cause a fire, electric shock or injury to individuals. INSTRUCTIONS FOR USE This product may differ slightly from the illustration This manual is designed to assist as far as possible in the use and maintenance of your electrical fan heater. This appliance is recommended ONLY FOR DOMESTIC USE. It can be connected to any AC electrical power socket (ordinary domestic current). Do not use any other type of socket. SPECIAL ATTENTION The use of extension leads is not recommended. However, if it is essential, ensure that the cable 1. Has a minimum size of H05VVF and not less than 15 amps, 2. If on a reel, it must be fully unwound ­ never use partially coiled up, 3. Is as short as possible (long cables can overheat and cause short-circuits), 4. That not more than one appliance at a time is used. USING YOUR HEATER 1. Place the heater on a flat, smooth and firm surface 2. Plug into a socket of 220-240Vac, 50 Hz. Make sure that no other appliances are plugged into the same socket as your heater. Turn the temperature control clockwise to the maximum position. Put the selector switch to the fan option or one of the two heater options. 6. When the room is at the temperature desired, turn the thermostat knob of the temperature control to the left (anticlockwise) until the appliance disconnects with a soft "click". It will now automatically start and stop to maintain the heat in the room constant. NOTE: THE TEMPERTURE CONTROL does not vary the fan speed. The heater is fitted with indicator pilot lights (RED). The pilot light shows that the unit is working. It lights up when the heater is in the working position. AUTOMATIC SAFETY SWITCH OFF TO AVOID OVERHEATING Your heater has an automatic switch off device. This device will switch the heater off if the temperature inside the casing rises too high. If the switch is activated, it will disconnect the fan elements until the unit is switched on again. [. . . ] · The BROWN wire is the LIVE and must be connected to the terminal, which is marked with the letter L or coloured RED. Always ensure that the cord grip is positioned and securely fastened. WARNING: ON NO ACCOUNT MUST EITHER THE LIVE OR NEUTRAL WIRES BE CONNECTED TO THE EARTH TERMINAL ~~~~~ Warranty ~~~~~ This product is guaranteed for 12 months from the date of purchase when the appliance is used solely for domestic purposes. For commercial use the product is guaranteed for 90 days from the date of purchase. [. . . ]