User manual PROFILO BM6284

[. . . ] reliable appliances Operating instructions 9000 533 738 (9004) Reset 3 sec. 10 9 Start 1 2 3 4 56 7 8 20 21 22 23 24 25 26 27 28 29 30 31 32 en Table of contents Washing the dishes . Protection against frost (Emptying the appliance) . 15 15 15 15 15 16 16 16 16 16 16 17 17 17 17 18 18 19 19 19 20 20 21 22 22 22 23 23 23 23 23 24 24 24 24 25 25 25 Safety instructions . 7 Switching off water softening system . [. . . ] ­ Press button P until the digital display H jumps to : . ­ Press button P until the displayed time corresponds with your requirements. ­ Press START button @, timer programming is activated. ­ To delete the preselected starting time, press the button P until is indicated on the digital display. You can change your programme selection at any time until the programme starts. Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. Terminating the programme (Reset) ­ Press START button @ for approx. ­ The programme sequence lasts approx. On the digital display H is indicated : . ­ Switch off ON/OFF switch (. End of programme The programme has ended when the value : is indicated on the numerical display H. Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. Changing the programme When the START button @ has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. 16 en Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. ­ Press and hold down the START button @. ­ Rotate programme selector 8 until : is indicated on the digital display H. The factory-set value : is lit on the digital display H (intensive drying off). Change the setting as follows: ­ By rotating the programme selector 8, you can switch intensive drying on : or off : . The set value is saved. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. [. . . ] ­ The socket must be near the appliance and freely accessible following installation. ­ The connection may be modified by technicians only. ­ A power cord extension may be purchased from customer service only. ­ Use only a residual current operated circuit-breaker which features the symbol , . [. . . ]