User manual PROFOTO ACUTE2 2400

[. . . ] Acute2 manual Profoto, Stockholm, Sweden. Warning Profoto generators and lamp heads are parts of a complete professional lighting system. Please read the instruction manual carefully before use. Flash tubes and modelling lamps emit considerable heat and may cause injury if not handled properly. Note, always unplug the lamp cable from the generator before changing the modelling lamp or flash tube. [. . . ] Changing flash tube is only to be done at a professional service station. Mounting the reflector: ·Remove the two ridged screws fixating the camera holder. ·Remove the four ridged nuts holding the outer and inner reflectors together. ·Run the lamp cable through the outer reflector and let the reflector slide into position. ·Reassemble the outer and inner reflectors using the ridged nuts. ·Reassemble the camera holder using the two ridged screws. 10 06 42 Softlight Reflector Ring 10 06 43 Close-Up Reflector Ring 13 Nomenclature 1. Sync Input 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 14 14 17. Full f-stop changes are done with the A- or/and B-switch. Fine adjustments or further f-stop reductions are done with the BRACKET dial. 17 Energy distribution One head 1. Reduce the energy one f-stop by switching A+B / A<- >B switch to position A<- >B. Further reduce the energy one or two f-stops by halving or quartering the energy with the A-switch. Use the dial BRACKET for fine adjustments and to further reduce the energy by two f-stops. Two heads Symmetrical light distribution 1. Reduce the energy one f-stop by switching A+B / A< -> B switch to position A<- >B. Further reduce the energy one or two f-stops by halving or quartering the energy with the B-switch. Use the dial BRACKET for fine adjustments and to further reduce the energy by two f-stops. Connect one head to the A socket and one head to one of the B sockets. Set the A+B / A <-> B switch in position A<->B. The energy for the two heads is now individually controlled. Reduce the energy one or two f-stops by halving or quartering the energy with the A-switch for the head connected to the A-socket. 18 4. Use the dial BRACKET for fine adjustments and to further reduce the energy by two f-stops. Three heads Symmetrical light distribution 1. [. . . ] For more detailed information please see below or contact your local Profoto dealer. With a gas generator with an output of 3000W or more 2 Acute2 generators can be operated. Make sure the petrol-electric generator set produces at least 2000W continuous output power for each connected unit. Always check this figure against the data sheet, as the model number does not always reflect the true power output. [. . . ]