User manual PROFOTO AIR REMOTE

[. . . ] Read and follow all safety instructions below carefully to avoid injuries or damages!Make sure that Profoto Safety Instructions is always accompanied the equipment!Profoto products are intended for professional use!Do not place or use the equipment where it can be exposed to moisture, extreme electromagnetic fields or in areas with flammable gases or dust! [. . . ] The Channel Indicator [1] corresponding to the selected radio channel (1­8) is illuminated. Synchronization All Profoto Air products that have the same radio channel set will be synchronized simultaneously. Group selection Groups are used to allow remote radio control of selected generator lamp heads. All lamp heads that are assigned to the same group will be controlled simultaneously. The lamp heads on a generator can be assigned to different groups. Lamp heads on different generators can be assigned to the same group. Group selection enables remote control of a group of lamp heads, for example the background light. It also allows a large light bank with several lamp heads to be controlled as one light source. Group selection on the Profoto Air Remote device is made with the Group Button [15]. The Group Indicator [16] corresponding to the selected radio group (A-F) is illuminated. The Master Button [12] is used to select all groups. www. profoto. com For remote radio control, both the Channel and Group settings on the Profoto Air Remote device must match the Channel and Group settings of the lamp heads in the group. With Profoto Air Remote it is possible to remotely control the power settings of the lamp heads in the group, to turn the lamp heads on/off and to turn the modeling light on/off. The Head Button I [9] is used to turn on the flash lamp heads. The Head Button o [10] is used to turn off the flash lamp heads. The Model Button I [8] is used to turn on the modeling light. The Model Button o [11] is used to turn off the modeling light. The Energy Button + [13] is used to increase the energy level. The Energy Button - [14] is used to decrease the energy level. Press the Energy Button < 2 seconds to adjust the energy level in 1/10 f-stop increments. Press the Energy Button > 2 seconds to adjust the energy level in 1 f-stop increments. If the energy level of any flash lamp head in the group is in minimum or maximum position, all energy levels will remain unchanged; see section Command confirmation below. Master mode In Master mode, the same remote control command is sent to all Groups on the selected Channel. [. . . ] Use the Energy Buttons [13] and [14] to increase/decrease the energy level of the selected group: Press the Energy Button < 2 seconds to increase/decrease in 1/10 f-stop increments. Press the Energy Button > 2 seconds to increase/decrease in 1 f-stop increments. Additional functions Silent mode Turn of the device. Press and hold down Head o Button and On Button to turn off silent mode. [. . . ]