User manual PROGRESS 6 IN 1

[. . . ] correct use · This dishwasher is only intended for washing household utensils suitable for machine washing. ⷠDo not put any solvents in the dishwasher. Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. Avoid opening the door whilst the appliance is in operation, hot steam may escape. [. . . ] For taller items, the cup racks can be folded upwards. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. Mix spoons with other cutlery to prevent them from sticking together. For best results we recommend that you use the cutlery grid provided (if the size and dimensions of the cutlery allow it). Before closing the door, ensured that the spray arms can rotate freely. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. To move to the higher position proceed as follows: 1. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. Carefully lift both sides upwards and then allow the mechanism to drop back down slowly, keeping hold of it. Never lift or lower the basket on one side only When the basket is in the higher position you will not be able to use the cup racks. After loading your machine always close the door, as an open door can be a hazard. this means that the function is active. To deactivate the function press the same buttons again until the indicator light corresponding to the Multitab function symbol goes off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. The activation/deactivation of the rinse aid is only possible with the Multitab function active. Simultaneously press and hold function buttons B and C, until the lights of function buttons A , B, and C start flashing. Press function button B, the lights of function buttons A and C go off while the light of function button B continues to flash. To activate the rinse aid dispenser, press button B again, the End indicator light To deactivate the rinse aid dispenser again, follow the above instructions until the End indicator light goes off. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and al- Cleaning the filters The filters must be checked and cleaned from time to time. Turn the handle about 1/4 a turn anticlockwise and remove the filter system 4. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). [. . . ] Do not immerse the water inlet hose or the safety valve in water. A water inlet hose with safety valve must only be replaced by the Service Force Centre. Water drain connection The end of the drain hose can be connected in the following ways: 1. to the sink outlet spigot , securing it to the underside of the work surface. [. . . ]