User manual PROGRESS MAXIMUS2300 PARKETTO

[. . . ] Never remove the mains plug from the socket by pulling on the cable. Avoid running over the mains lead with the appliance or the vacuum brush. The cover cannot be closed unless a paper filter has been inserted. Always ensure that a paper filter as well as a MICROFILTER and a HEPA filter are inserted. [. . . ] For this reason, if there is a malfunction in your appliance please contact your specialist dealer or PROGRESS customer service directly. The accessories can be connected by pushing and twisting, and can be disconnected by pulling them apart and twisting. It locks in place and can be rotated all the way around. Press the release button and pull out the connector in order to remove the suction hose. Pull out the cable and insert the plug into the mains socket. Press the foot button; the cable rewinds automatically when vacuuming has been completed. Adjust the Telescopic Tube (depending on model) Using the floor nozzle* For the daily care of carpets and hard floors. Without being changed over manually, the floor nozzle is entirely suited for daily vacuuming of carpets and hard floor surfaces such as parquet, tiles, linoleum, etc. Using the floor nozzle* For the daily care of carpets and hard floors. The floor nozzle may be changed over manually. Switching on and off You can switch the appliance on and off by pressing the On/Off button. Crevice and upholstery nozzle stored in the appliance For specific cleaning requirements, two additional parts are included with the vacuum cleaner in an integrated accessories compartment*. Power adjustment - Rotary control* The suction power can be varied to suit individual vacuuming requirements using the electronic power adjuster. Power adjuster Secondary air regulator* Using the regulator on the handle, you can reduce the suction power, e. When vacuuming light items (net curtains, rugs). The wider you open the regulator, the lower the suction power at the nozzle becomes Prior to maintenance or cleaning, ensure that the appliance is switched off and that the mains plug has been removed from the socket: Insert the new paper filter as far as it will go in the guide rails; only then can the lid be closed. The cover cannot be closed unless a paper filter has been inserted. Changing the microfilter We recommend replacing the microfilter at each fifth paper filter replacement, and at the latest when there is a clean dust bag and the dust level indicator is completely red with the nozzle raised. Changing the paper filter The paper filter must be replaced if the window on the filter replacement indicator is completely red when the appliance is operating at maximum power and the nozzle is raised from the floor. The paper filter should be replaced even if it does not appear to be full because fine dust can block the pores in the surface of the filter. [. . . ] This can be avoided if you set the electronic power adjuster to the lowest power level and then select a higher level after switching the appliance on. Your vacuum cleaner can be fitted with a gentle startup control which reduces the starting current to the motor and therefore prevents the electric circuit cut-out being triggered under normal conditions. It is possible that there will be a delay of about 4 seconds in the appliance starting up on the lowest power level. To make the appliance easier to store and carry, slide the floor nozzle into the tool rail. [. . . ]